Hobbes HDMIMAPPERE-852 User manual

HDMImapper
wire map cable tester
user manual
Model No. E-852

Introduction
Product Description
Features
Specifications
Instruction for operation
Remarks
Warranty Information
03
05
08
09
10
16
17

10
Instruction For Operation
•To test and troubleshoot 19 pin and
shielding connections of the HDMI
cable, plug both ends of the cable to
be tested into the unit’s two
HDMI connections.

11
•Press the “test” button once, then the
unit begins to test the cable pin to
pin status.
a.If the cable is ok, the good/bad LED
will be lit in green and a single beep
“Bi-” will sound.
b.If the cable is bad, the good/bad LED
will be lit in red and 3 consecutive beep
“Bi-Bi-Bi” will sound.
c.The “open”, “short”, “miswire” LED
will be lit in red color to indicate cable
fault status.

13
• Test Results
green (good)
red (bad)
a.Open:
Press “test” button once again, the LED bar
will illuminate in red color to indicate which
pins are open.
Note: PIN 2, 5 are opened.

14
b.Short:
green (good)
red (bad)
Press “test” button once again, the
LED bar will illuminate in red color to
indicate which pins are shorted.
Note: PIN 8, 10 are shorted.