Hobby King Airoso F3A User manual

AIRCRAFT SPECIFICATIONS：
Wing Span: 1576mm/62"
WingArea: 40.05 Sqdm/ 620.8 Sqin
Lenght:1528.7mm/60.19in
Weight: 2300g RTF less battery
RECOMMENDED EQUIPMENT：
Motor: BL4030/10
Radio: 4 channels, 4 servos
Battery: 5S/6S 3800mAh-5000mAh
ESC: 60A-80A
Warning! This model is not a toy.
It is designed for maximum performance. Please seek
advice if one is not familiar with this kind of electric
powered precision model.
Operating this model without prior preparation may cause
in juries.
Remember, safety is the most important thing. Always keep
this instruction manual at hand for quick reference.

1.Wing
Wings Part List Apply instant glue
Cut the covering for installing
the
aileron’s servos
Cut the covering for installing
the
aileron’s horn
Before install the horn needs sanding Apply epoxy glue

Uses servo draft line Install aileron’s servos
Weld push-and-pull pole Complete aileron servos system
2.Stabilizer/Vertical/Tail Wheel
Stabilizer Part List Vertical/Tail Wheel Part List

Cut away the cover film Cut away the wood
Drill diameter 3mm hole Apply epoxy glue
Before install horizontal Apply instant glue
Apply instant glue Apply epoxy glue

Apply epoxy glue Bend the Tail Wheel
Cut away wood install the Tail Wheel Drill diameter 2mm hole
Apply instant glue Apply epoxy glue
Apply instant glue

Install elevator servo Apply epoxy glue
Install rudder servo
Weld elevator and rudder
push-and-pull pole
Complete elevator servo system Complete rudder servo system

3.Main Landing Wheel
Main Landing Wheel Part List Apply epoxy glue
Cut this part away Install main landing wheel
Install main landing wheel Install main landing wheel
Complete Main Landing Wheel installing

4.Cowing/ Motor
Motor mounting Part List Cut this part away for installing motor
Install motor Install motor frame
Apply epoxy glue Apply epoxy glue

Cowing Part List Draw a mark for drill the cowing ’s hole
Judging by the mark to drill the cowing ’
s hole
Complete cowing install