Hobby King Stinson Reliant User manual

AIRCRAFT SPECIFICATIONS:
Wing Span: 2160.5mm/80.06"
Wing Area: 61.21 Sq dm/ 948.73 Sq in
Lenght:1490.2mm/58.67in
Weight: 3600g
RECOMMENDED EQUIPMENT：
Engine: 26--35CC gas engine
Radio: 4 channels, 6 servos
Warning! This model is not a toy.
It is designed for maximum performance. Please seek
advice if one is not familiar with this kind of electric
powered precision model.
Operating this model without prior preparation may cause
in juries.
Remember, safety is the most important thing. Always keep
this instruction manual at hand for quick reference.

1.Wing
Wings Part List Fix the hinge with instant glue
Cut the covering away for installing the
aileron servo
Fix the aileron’s servo
Fix the aileron horn Completed aileron servo system’s installing

2.Main Landing Wheel
Main Landing Wheel Part List
passes the wheel shaft and M4 Wheelchocks
through wheel
Put the complete wheel parts into the wheel
cowling then locking the M4 Wheelchocks
Fix the main landing chassis
Cut the covering away Fix the main landing chassis’s
decorative cover

3.Stabilizer/Vertical/Tail Wheel
Stabilizer Part List
Cut the covering away for install
the elevator’s servo and horizontal
tail
Must be installing the elevator’s servos
first
Put the barrel bolt through the
fuselage
Fix the horizontal tail Fix the hinge with instant glue

Completed the elevator servo system
installing
Vertical/Tail Wheel Part List
Install the tail wheel and cut the
redundant steel wire
Fix the tail wheel set Fix the rudder hinge with instant gle

Fix the tail wheel set and rudder linkage
controls Fix the rudder’s servo
Fix the rudder horn Judging by the picture passes through the
steel wire and clamp the aluminium tube
for fixing the steel wire

Completed the rudder servo system
installing
4.Wing Support
Fix the wing with 2pcs M4*25 hand
screw
Scuff the aluminium sheet with sand
paper to ensure a good glue bond
Fix the aluinium sheet with epoxy glue Fix the wing support with 4pcs M3 cross
head screws

5.Canopy/Cowling/Engine/Fuel Tank
Engine Mounting/Fuel Tank Part List Canopy/Cowlling Part List
Draw a mark for drilling the hole to
fix 2pcs nuts with claws
Judging by the mark to drilling the hole
Pressed-into 2pcs M3 nuts with claws Fix the fuel tank

Fix the Canopy
Fix the plywood with epoxy glue
Fix the engine support with 4pcs
M4*30 socket head screw
Install the engine and the Throttle
Pushwire
Draw a mark for drilling the hole to
fix the cowling
Judging by the mark to drilling the hole

Fix the cowling
6.Canopy/Cowling/Engine/Fuel Tank
Side Window Part List Fix the PVC with instant glue
Fix the PVC with instant glue Fix the side windows