Hobby King PT-17 User manual

AIRCRAFT SPECIFICATIONS：
Top Wing Span: 1200mm/47.25in
Top Wing Area:20.08 Sqdm/311.29 Sqin
Bottom Wing Span: 1159mm/45.63in
Bottom Wing Area: 20.45 Sqdm/ 316.93 Sqin
Lenght:938mm/36.93in
Flying Weight: 1650g less battery
RECOMMENDED EQUIPMENT：
Motor: BL2826
Radio: 4ch+4servos
Warning! This model is not a toy.
It is designed for maximum performance. Please seek
advice if one is not familiar with this kind of electric
powered precision model.
Operating this model without prior preparation may cause
in juries.
Remember, safety is the most important thing. Always keep
this instruction manual at hand for quick reference.

1.Wing
Wings Part List Fix the wings with epoxy glue
Fix the bottom wing hinge with instant
glue
Fix the bottom wing abdominal cover
with
epoxy glue and drill two diameter 10mm
hole for fixing the bottom wing
Drill two diameter 4mm hole for
fixing the bottom wing
Cut the covering away for passing
through the servo’s extension line

Drill 2 diameter 3mm hole for
fixing the bottom wing
Cut the covering away for fixing the
aileron servo
Fix bottom wing aileron servo and
horn
Completed the bottom wing servo’s
installing
Wing Support Part List Cut the covering away for fixing the
Wing support

Apply epoxy glue
Fix the bottom wing Fix the top wing hinge with instant
glue
Cut the covering away for fixing the
Wing support
Cut the covering away for fixing the
Wing support

Apply epoxy glue
Apply epoxy glue
Fix the aluminium wing support with
8pcs M3*12 Socket head screw and
8pcs M3 nut
Fix the plywood wing support with
8pcs M3*12 Socket head screw and
8pcs M3 nut

Fix the top wing horn Completed top wing and bottom wing
installing
Completed the top wing and bottom wing
aileron servo system installing
2.Main Landing Wheel
Main Landing Wheel Part List Cut the covering away for fix the main
landing wheel

Applay epoxy glue Passes the shaft through the wheel and
the main landing chassis. Then fixed
with M4 skidproof nut
Fix the main landing wheel
3.Stabilizer/Vertical/Tail Wheel
Stabilizer / Vertical / Tail Wheel
Part List
Draw a line for cutting the covering
away

Draw a line for cutting the covering
away
Judging
by
the
line
to
cutting
the
covering away
Fix the horizontal tail and the vertical
tail with instant glue
Cut the wood away and drill a diameter 2mm
hole for fixing the elevator linkage rod
Fixing the elevator linkage rod with
epoxy glue
Fix the hinge with instant glue

Install the tail wheel and bend the steel
wire
Fix
the
tail
wheel
with
4pcs
tapping
screws
Cut away the wood and drill a diameter 2mm
hole for fixing the tail wheel steel wire
Fix
the
tail
wheel
steel
wire
with
epoxy
glue
and
fix
the
hinge
with
instant glue
Fix the elevator’s horn Fix the rudder’s horn

Install the elevator push-and-
pull
rod
Install the rudder push-and-
pull
rod
Completed
the
elevator
and
rudder
servo’s system installing
4.Canopy/Cowling/Motor Mounting
Cowl/Motor mounting Part List Fix the motor with 4pcs M3*15 Socket
head screw and 4pcs M3 skidproof nut

Fix the PVC ornament with epoxy glue Draw a mark for drilling the cowling’s
hole
Judging by the mark to drilling the
hole
Fix the cowl
Fix the PVC ornament with epoxy glue Install the canopy