Hollyland Solidcom User manual
Hollyland Solidcom 4-Slot Charging Case
V2.0.0
User Manual
Packing List
① Charging Case ×1
② USB-A to USB-C Cable ×1
③ User Manual ×1
④ Warranty Card ×1
Note: The quantity of the items depends on the product conguration.
①
③
②
④
1
Product Inteaces
① Charging Indicator (Orange: Charging/Green: Fully Charg e d )
② Charging Contact
③ USB-C Charging Inteace
① Indicator Light Stays Orange: Charging (for Each Batte Slot)
② Indicator Light Stays Green: Fully Charged (for Each Batte Slot)
Charging Indicator:
2
1
2
Charging Case：
Parameters
Inteace USB-C inteace
Charging contact
Dimensions 89.68x110.85x27.00mm (3.53"x4.36"x1.06")
Weight About 140g (4.94oz)
Voltage Range 4.5V–12V (Typical: 5V/2A)
Charging Current
for Each Slot About 420mA
Charging Time About 2.5 hours
Fast charging protocols are not suppoed, but fast chargers
can be used for a 5V power supply.
3
Fast Charging
Compatible Model Headset batteries for Solidcom series intercom systems
Safety Precautions
Do not place the product near or inside heating devices (including but not limited to microwave ovens,
induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, and gas stoves) to
prevent the batte from overheating and exploding.
Do not use non-original charging cases, cables, and batteries with the product.
The use of non-original spare pas may cause electric shock, re, explosion, or other dangers.
4
Suppo
If you encounter any problems in using the product or need any help, please contact Hollyland Suppo
Team via the following ways:
Hollyland User Group
HollylandTech
HollylandTech
HollylandTech
suppo@hollyland-tech.com
www.hollyland-tech.com
5
Statement
All copyrights belong to Shenzhen Hollyland Technology Co., Ltd.
Trademark Statement
Without the written approval of Shenzhen Hollyland Technology Co., Ltd., no organization or individual
may copy or reproduce pa or all of any written or illustrative content and disseminate it in any form.
Note:
Due to product version upgrades or other reasons, this User Manual will be updated from time to time.
Unless otherwise agreed, this document is provided as a guide for use only. All representations,
information, and recommendations in this document do not constitute warranties of any kind,
express, or implied.
6
Any changes or modications not expressly approved by the pay responsible for compliance could
void the user's authority to operate the device. This device complies with Pa 15 of the FCC Rules.
Operations are subject to the following two conditions:
(1) This device may not cause harmful inteerence.
(2) This device must accept any inteerence received, including inteerence that may cause undesired
operations.
The device has been tested and complies with FCC SAR limits.
FCC Radiation Exposure Statement:
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Pa 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
inteerence in a residential installation. This device generates, uses, and can radiate radio frequency
energy, and if it is not installed and used in accordance with the instructions, it may cause harmful
inteerence to radio communications. However, there is no guarantee that inteerence will not occur
in a paicular installation. If this device does cause harmful inteerence to radio or television reception,
which can be determined by turning the device o and on, the user is encouraged to t to correct the
inteerence by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the distance between the device and the receiver.
–Connect the device to an outlet on a circuit dierent from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Note:
FCC Requirement
7
Other manuals for Solidcom
1
Table of contents
Other Hollyland Batteries Charger manuals
