Holman 40233 User manual

Holman
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
20220809R1 DATE: ________________
Instruction Guide
40233

Instructions –40233
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 1
PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.
Warning
Always check for wires, fuel tanks and lines, brake lines and other important
vehicle functionality items prior to drilling and installing all products.
Table of Contents
Tools Needed..................................................................................................................................1
Before You Begin ............................................................................................................................1
Parts List..........................................................................................................................................1
Hardware.........................................................................................................................................2
Step 1 –Align spool Holder with shelf.............................................................................................2
Step 2 –Install.................................................................................................................................3
Tools Needed
10mm Socket and Wrench
Before You Begin
Read all instructions prior to assembling or installing any Holman product.
Always locate your installation locations prior to performing any work.
ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE OR OTHER
PRODUCTS.
Parts List

Instructions –40233
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2
Hardware
Step 1 –Align Spool Holder With Shelf
Align the spool holder with the van interior bottom holes on the shelf.
NOTE: any other location besides the bottom holes will require drilling.

Instructions –40233
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3
Step 2 –Install
Using one M6 x 16mm hex head bolt, M6 lock washer, and M6 oversized washer, per hole.
Tighten the bolts to secure the spool holder to the shelf side.
GO BACK AND TIGHTEN ALL HARDWARE.
INSTALLATION IS COMPLETE.