Homelegance 4522-14 User manual

F ( 1: 5 )
ASSEMBLY INSTRUCTION
INSTRUCTIONS D' ASSEMBLANGE
Keep all hardware parts out of reach of children.
straps before you start to assemble.
Do not tighten all screws / bolts until all completely assembled.
Remove all wrapping materials, including staples & packing
Check to be sure that you have all parts and hardware.
as a rug or carpet to avoid the parts from being scratched.
Place all wooden parts on a clean and smooth surface such
I M P O R T A N T N O T E :
QTY/PCSDESCRIPTION
PART LIST
LISTE DE PIECES
1
NO
1 OF 3
Description :
4522-14 / 4522WH-14
Item No :
HUTCH
MADE IN MALAYSIA
HUTCH 1 PC
2 CREDENZA 1 PC B
QTY/PCS
3 PCSI-BRACKET / BRAKIT
CSK SCREW / VIS 3.5 x 16mm
NO
HARDWARE LIST
LISTE DE QUINCAILLERIE
DESCRIPTION
A
6 PCS
C FURNITURE TIPPING RESTRAINT 1 SET
1
2
Re-assemble handle from inside
to outside position.
B
1
A

MADE IN MALAYSIA 2 OF 3
Item No : 4522-14 / 4522WH-14
HUTCH
ASSEMBLY INSTRUCTION
INSTRUCTIONS D' ASSEMBLANGE
Description :
1
2
C
WALL

G ( 1 : 6 )
J ( 1 : 10 )
L ( 1 : 10 )
M ( 1 : 15 )
P ( 1 : 15 )
R ( 1 : 11 )
T ( 1 : 7 )
U ( 1 : 16 )
V ( 1 : 13 )
W ( 1 : 13 )
G
J
L
M
P
R
T
U
V
W
MADE IN MALAYSIA
ASSEMBLY INSTRUCTIONS
DESCRIPTION :
ITEM NO :
TO REMOVE DRAWER:
STEP 1 : EXTEND THE BOX DRAWER TO ITS FULL EXTENSION.
STEP 2 : LOCATE THE DRAWER SLIDE LOCK ON EACH SIDE OF THE DRAWER BOX.
PULL UP THE LOCK ON THE LEFT SIDE OF THE DRAWER BOX AND PUSH DOWN
THE LOCK ON THE RIGHT SIDE OF THE DRAWER BOX IN THE SAME TIME AND
PULL DRAWER STRAIGHT OUT UNTIL SLIDE DRAWER MEMBERS DISENGAGE
FROM CABINET MEMBERS.
STEP 3 : REMOVE THE DRAWER.
HUTCH
4522-14 / 4522WH-14
3 OF 3
ASSEMBLY INSTRUCTIONS FOR DRAWER REMOVAL AND REINSTALL
FOR CASEGOODS
TO REINSTALL DRAWER :
MAKE SURE THE DRAWER WILL BE RE-INSTALL TO ITS ORIGINAL POSITION.
STEP 1 : INSERT DRAWER BY PULLING TRACK ON THE LEFT AND RIGHT CABINET MEMBERS
ALL THE WAY FORWARD (INCLUDING BALL BEARING RACK)
STEP 2 : ALIGN TRACKS ON DRAWER WITH SLIDERS AND PUSH IN THE DRAWER
UNTIL THERE IS AUDIBLE "CLICK" SOUND.
STEP 3 : CHECK FOR PROPER ALIGNMENT BY INSPECTING DRAWER FRONT MARGINS
FOR SPACING AND SQUARENESS.
OPEN AND CLOSE SLOWLY SEVERAL TIMES TO ENSURE THE PROPER INSTALLMENT.
IF THERE IS ANY UNEVEN, PLEASE REPEAT STEP OF REMOVAL AND REINSTALL THE DRAWER.
STEP 3 PUSH DOWN
STEP 2
PULL UP
STEP 2
STEP 1
STEP 3
STEP 2
Lock
Left side view
Lock
Right side view
Bearing
STEP 1