Honeywell Dolphin 75e Instruction Manual

75E-AND-ENUS-IG Rev B, 5/15
Power Up Instructions
Follow the steps below the first time you power up the terminal.
1. Install the battery.
2. Charge the battery for 6 hours.
3. Press the Power button. When the Honeywell logo appears and the right green LED turns on,
press and hold both the Volume Up and Home buttons at the same time. 

If the terminal shuts down, repeat step 3.
4. Release the buttons when the green LED turns Off. After approximately 30 seconds, the
system update screen appears. When the system update is finished, the lock screen appears.
For more information on how to use the Dolphin 75e, see the enclosed Quick Start Guide.
Power
(top)
Volume Up
(side)
Do not remove battery during update!
75E-AND-ENUS-IG Rev B.fm Page 1 Tuesday, May 19, 2015 6:18 PM

Support
To search our knowledge base for a solution or log into the Technical Support portal and report a
problem, go to www.hsmcontactsupport.com.
User Documentation
To download the user guide, go to www.honeywellaidc.com.
Limited Warranty
For warranty information, go to www.honeywellaidc.com and click Resources > Warranty.
Ensure all components are dry prior to placing the battery in the terminal. Mating wet

components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery
may result in damage not covered by the warranty.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of
any non-Honeywell peripherals, cables, or power adapters may cause damage not covered
by the warranty.
Trademarks
Android and other marks are trademarks of Google Inc.
Disclaimer
Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other
information contained in this document without prior notice, and the reader should in all cases
consult HII to determine whether any such changes have been made. The information in this 
publication does not represent a commitment on the part of HII.
HII shall not be liable for technical or editorial errors or omissions contained herein; nor for 
incidental or consequential damages resulting from the furnishing, performance, or use of this
material. HII disclaims all responsibility for the selection and use of software and/or hardware to
achieve intended results.
This document contains proprietary information that is protected by copyright. All rights are
reserved. No part of this document may be photocopied, reproduced, or translated into another
language without the prior written consent of HII.
Copyright © 2015 Honeywell International Inc. All rights reserved.
!
!
!
75E-AND-ENUS-IG Rev B.fm Page 2 Tuesday, May 19, 2015 6:18 PM