WARNING To ensure compliance with electrical safety standards,
CSA Certified/UL Listed LPS or Class 2 power adapters are required. Power
over Ethernet (PoE) shall be provided by listed Information
Technology Equipment meeting the IEEE 802.3af PoE standard. The
PoE is not intended to be connected to exposed (outside plant)
networks.
• Read and keep these instructions.
• Please ensure that your installation area can safely support the weight of the camera.
• Do not aim the camera toward an extreme light source to prevent damage to the CCD.
• This camera is rated for indoor operation. Do not expose this camera to rain or moisture.
• Do not touch the camera lens.
• Do not drop the camera or subject it to physical shock.
• Do not use a strong or abrasive detergent when cleaning the camera.
• Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments
(where the operating temperature is outside the recommended range of -22° F to
122°F [-30°C to 50°C]).
Regulatory Statements
Information to the User: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Note Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This Class A digital apparatus complies with Canadian ICES-003.
FCC Statement of Compliance
Manufacturer's Declaration of Conformance
The manufacturer declares that the equipment supplied with this guide is compliant
with the European Parliament and Council Directive on the Restrictions of the use of certain
hazardous substances in electrical and electronic equipment (2011/65/EU), General Product
Safety Directive (2001/95/EC), and the essential requirements of the EMC
Directive (2014/30/EU), conforming to the requirements of standards EN 55022 for
emissions, EN 50130-4 for immunity, and EN 60950-1 for electrical equipment safety.
WARNING
employed when powering the camera from 24 V AC.
CAUTION Invisible LED radiation (850 nm). Avoid exposure to beam.
CAUTION This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to
take adequate measures.
To comply with EN50130-4 requirements, a UPS should be
Waste Electrical and Electronic Equipment (WEEE)
Correct Disposal of this Product (applicable in the European Union and other
European countries with separate collection systems).
This product should be disposed of, at the end of its useful life, as per applicable
local laws, regulations, and procedures.
www.honeywell.com/security
+1 800 323 4576 (North America only)
https://www.honeywellsystems.com/ss/techsupp/index.html
Document 800-21792 Rev. A
Cautions and Warnings
THIS SYMBOL INDICATES THAT
DANGEROUS VOLTAGE
CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
THIS SYMBOL INDICATES THAT
IMPORTANT OPERATING AND
MAINTENANCE INSTRUCTIONS
ACCOMPANY THIS UNIT.
1
3
2
H4W2GR1
Important Safeguards
1
2
3
4
H4W2GR1 001F55241124 192.168.1.188
1xx
5
1234
admin
H4W2GR1- 001F55241124
H4W2GR1- 001F55241124
H4W2GR1 001F55241124 192.168.1.188
6
****
****
4-4
