horiba Laqua Act ES-71 Installation guide

CODE:GZ0000340572B
January, 2017 © 2017 HORIBA Advanced Techno Co., Ltd.
Quick Manual
Portable Conductivity Meter ES-71
MEASCAL DATA
LIGHT
SETMODE
ENT
Preparation
② Press the power key of the meter
① Connect the electrode to the meter
MEASCAL DATA
LIGHT
SETMODE
ENT
Press
Temperature connectorElectrode connector
http://www.horiba-water.com

②Start the measurement
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
①Enter the set up mode ①Enter the measurement mode
MEASCAL DATA
LIGHT
SETMODE
ENT
×3
MEASCAL DATA
LIGHT
SETMODE
ENT
②Set the cell constant
Set the cell constant
Press
Press three times
Press
MEASCAL DATA
SETMODE
Immerse up to
the hole in the
lower part of
the cell.
Press
Press
When changes from the blinking state
to the lit state, measurement is complete.
Measurement
When the batteries run out or the meter will not be used
for a long period, remove the batteries.
NOTE
MEASCAL DATA
LIGHT
SETMODE
ENT
3552-10D
1.065 × 100 m -1（1cm-1)
Check the label on the electrode.
Example)
②①
MEASCAL DATA
LIGHT
SETMODE
ENT
To measurement
① Press to set the digit
number of cell constant.
Register it with .
② Press to set the number
of cell constant.
Change the digit with .
Register it with .
③ Press to reect the changes.