horiba LAQUA COND DS-72 Installation guide

COND METER DS-72
CAL MEAS DATA
COND METER DS-72
CAL MEAS DATA
January, 2017 © 2017HORIBA Advanced Techno Co., Ltd.
Quick Manual
COND meter DS-72
Preparation
①Connect the electrode to the COND meter
Electrode terminal Temperature sensor terminal
②Press the power button of the COND meter
☆Press the power button for 2 seconds.
※Wait for 10 seconds after connecting
the AC adapter before pressing
the power button.
CODE :GZ0000272697A

3552-10D
1.057 × 100 m -1（1cm-1)
COND METER DS-72
CAL MEAS DATA
COND METER DS-72
CAL MEAS DATA
COND METER DS-72
CAL MEAS DATA
COND METER DS-72
CAL MEAS DATA ① ②
① ②
Set the cell constant
①Enter the set up mode
To measurement
②Set the cell constant
Check the label on the electrode.
Measurement
①Enter the measurement mode
②Start the measurement
When the indication changes from
the blinking state to the lit state,
measurement is complete.
① Use the numerical
keypad to enter
and press
the button.
Example.)
Conrm that the instantaneous values
is stable, then press button.
Immerse the electrode in the sample
until the liquid junction part is fully submerged.
② Set the digit number
with
▲▼ button.
Resister it with button.