HP StorageWorks XP512 - Disk Array User manual

HP SureStore E Disk Array XP512

Site Prep Guide

Notice
© 2000, Hewlett-Packard Company.
Order number A5951-90915
E0800 A5951-96150
Hewlett-Packard Company makes no warranty of any
kind with regard to this material, including, but not
limited to, the implied warranties of merchantability and
fitness for a particular purpose. Hewlett-Packard shall not
be liable for errors contained herein or for incidental or
consequential damages in connection with the furnishing,
performance, or use of this material.
This document contains proprietary information, which is
protected by copyright. No part of this document may be
photocopied, reproduced, or translated into another
language without the prior written consent of Hewlett-
Packard. The information contained in this document is
subject to change without notice.
Warranty
If you have any questions about the warranty for this
product, contact your dealer or local HP sales
representative.
Trademarks
Windows NT, Microsoft, Windows, MS Windows, and
MS-DOS are U.S. registered trademarks of Microsoft
Corporation.
Other reserved names are trademarks of the respective
companies.
Safety notices
Any servicing, adjustment, maintenance, or repair that
must be performed only by authorized service-trained
personnel.
Caution Denotes a hazard that can cause
hardware or software damage.
WARNING Denotes a hazard that can cause
personal injury or death.
2

3
Revision History 7
Updates 8
1 Introduction 9
2 The Site Prep Team and Tasks 11
The Site Prep Team 12
The HP Sales Representative (SR) 12
The HP Customer Engineer (CE) 12
The HP Application Software Engineer (ASE) 12
The Customer 13
Site Prep Technical Tasks 14
Site Planning Timetable 16
3 Preparing for Installation 17
Safety Requirements 18
Site Safety Consideration 18
Fire Safety 18
Equipment Servicing Hazards 18
General Computer Room Requirements 19
Space planning 19
The HP SureStore E Disk Array XP512 20
CONTENTS

4 HP SureStore E Disk Array XP512: Site Prep Guide
Physical Requirements 21
Dimensions 21
HP SureStore E Disk Array XP512 Weight 23
Specific Component Dimensions And Weights 23
Service and Cable Routing Space Requirements 27
Data Comm Requirements 38
Phone Home With Continuous Track 38
Local Area Network (LAN) 39
Outside Phone Line 40
Electrical Requirements 41
Line Voltage 41
Branch Circuit Breakers 41
Frequency 42
AC Line Voltage Requirements for the HP SureStore E Disk Array
XP512 42
Safety and Dedicated Ground 44
HP SureStore E Disk Array XP512 Grounding Requirements 44
Receptacles 45
Power Line Transients 45
Maximum Peak Inrush and Crest Factor 46
Sources of Electrical Interference 47
3-Phase AC Cabling for USA 49
Connecting the External Power Supply Cord 49
Branch Circuit Requirements 49
3-Phase AC Cabling for Europe 51
Connecting the Power Supply Cord 51
Branch Circuit Requirements 52
Single-Phase AC Cabling for USA 53
Connecting the Power Supply Cord 53
Branch Circuit Requirements 55
Single-Phase Cabling for Europe 56
Connecting the Power Supply Cord 56
Branch Circuit Requirements 57

Contents 5
Uninterruptible Power Supply (UPS) 58
UPS Features 58
UPS Limitations 58
Power Requirements: Single Secondary Input (Primary Offline) 59
Reference Supplier Information 59
Environmental Requirements 60
Air Conditioning Ducts 60
Humidity 60
Dust and Pollution Control 61
HP SureStore E Disk Array XP512 Temperature and Humidity
Specifications 61
Heat Dissipation 64
Altitude 65
Acoustics 66
Delivery Space Requirements 67
4 Upon Receipt of Your HP SureStore E Disk Array
XP512 69
Checking for Shipping Shortage and Damage 70
Unpacking the Cartons 71
Index 73

6 HP SureStore E Disk Array XP512: Site Prep Guide

Revision History 7
Revision History
11 July 2000 First release.
23August 2000 Second release; filled in some missing values on the
weight table (Chapter 3)

8 HP SureStore E Disk Array XP512: Site Prep Guide
Updates
For the most current information about HP SureStore E XP products, visit
the support web site:
www.hp.com/support/xp512
For information about product availability, configuration, and connectivity,
consult your HP account representative.

9
1
INTRODUCTION
The objective of a site prep is to prepare your site for the successful and
timely installation of your HP SureStore E Disk Array XP512. Proper site
preparation and maintenance is vital to the reliability of your HP SureStore
E Disk Array XP512. A site prep is a delicate balance of equipment design
criteria, site environmental variables, your business needs, and your budget
constraints. This guide contains site preparation information for the HP
SureStore E Disk Array XP512. Other site preparation resources may also
be available to you. Consult with your HP representative specializing in the
HP SureStore E Disk Array XP512.
The contents of this manual are arranged as follows:
Chapter 1 This introduction chapter.
Chapter 2 Introduction to HP’s service organization and site
planning services. It also outlines your responsibilities
and the responsibilities of HP service personnel.
Chapter 3 Site preparation and planning information specific to
the HP SureStore E Disk Array XP512.
Chapter 4 Information on the receipt of your HP SureStore E Disk
Array XP512.

10 HP SureStore E Disk Array XP512: Site Prep Guide

11
2
THE SITE PREP TEAM AND TASKS
The HP service organization is committed to making sure you receive the
maximum benefits of your HP SureStore E Disk Array XP512. Brief
descriptions of the HP team and how they can assist you are included in this
chapter. You are also an integral part of the site prep team. Your
responsibilities are also described here. The table on page 14 provides a site
inspection checklist and includes a reference for pertinent information.

12 HP SureStore E Disk Array XP512: Site Prep Guide
The Site Prep Team
The site prep planning team is responsible for determining site location and
location size, ensuring that construction requirements and local codes are
met, and scheduling all events related to site completion to prepare for the
successful installation and maintenance of the HP SureStore E Disk Array
XP512. The site prep team consists of the following personnel:
• sales representative
• customer engineer
• application software engineer
•customer
The HP Sales Representative (SR)
The sales representative is your primary point of contact. A sales rep
coordinates all the HP resources to ensure successful delivery and
installation of your disk array.
The HP Customer Engineer (CE)
The HP CE is trained and experienced in the installation of your disk array.
They have the tools, parts, and knowledge to install and maintain your HP
SureStore E Disk Array XP512. The CE will also assist you in determining
your site prep requirements.
The HP Application Software Engineer (ASE)
The HP ASE is a software technical specialist trained in configuring your
HP SureStore E Disk Array XP512. The ASE can install and configure all
software applications for your disk array.

The Site Prep Team and Tasks 13
The Customer
As part of the site prep planning team, your responsibilities include
scheduling, planning, and preparing a suitable environment for the HP
SureStore E Disk Array XP512. Your site team may include a site specialist
for your computer room, a site electrician, and other site personnel
specializing in your site computer room. Responsibilities include proper:
• physical space necessary for proper subsystem function and
maintenance activity, including space and weight limitations and
system accessibility
• electrical power input including adherence to:
local building codes
local electrical codes
local safety codes
• connectors and receptacles, including
hardware or cables
network links
telephone equipment
equipment supplied by companies other than HP
• environmental requirements including:
temperature requirements
humidity limitations
• floor ventilation areas
• cable access holes
• RJ-11 analog telephone lines for Phone Home capabilities

14 HP SureStore E Disk Array XP512: Site Prep Guide
Site Prep Technical Tasks
Use the following table as an action item checklist.
Customer Summary
Customer:
Contact: Telephone:
Address: HP CE:
Date: Time:
Safety Yes No Reference
áwhen completed
qIs there a fire protection system in the computer room qqpage 16
qAre there any equipment servicing hazards? qqpage 16
Computer Room Yes No Reference
áwhen completed
qIs there a copy of the existing floor plan? q q page 17
qIs there a copy of the newly developed floor plan? q q page 17
qIs there adequate space for airflow and maintenance needs? q q page 17
qIs the computer room structurally complete? q q page 19
qIs the raised floor adequate for equipment loading? q q page 20
qAre there channels or cut-outs for cable routing? q q page 39
qIs antistatic flooring installed? qqpage 21
qIs there a telephone jack for Phone Home configuration? q q page 38
qIs there a telephone line for customer engineer use? q q page 40
qIs there a private LAN available? q q page 39

The Site Prep Team and Tasks 15
Electrical Yes No Reference
áwhen completed
qAre two AC outlets/DKU (on different lines) available for the
proposed equipment?
qqpage 44
qDoes the input voltage correspond to equipment specifications? qqpage 41
qAre the input circuit breakers adequate for equipment loads? qqpage 41
qDoes the input frequency correspond to equipment specifications? qqpage 42
qAre lightening arresters installed? qqpage 47
qHas all sources of electrical interferences been corrected? qqpage 47
Air-Conditioning Yes No Reference
áwhen completed
qCan the temperature be maintained between 20o- 30oC? qqpage 61
qCan temperature changes be held to less that 5oper hour? qqpage 61
qCan humidity level be maintained between 40% and 60%? qqpage 61
Building Access and Security Yes No Reference
áwhen completed
qIs there access control to the computer room? qqpage 67
qIs there access control for the customer site? qqpage 67
qWill any stair-walkers, lifts, ramps, floor coverings, or ladders be
required to install the equipment?
Define: _____________
qqpage 67
qWill the equipment fit through all doors, corridors, and in lifts, both
in size and weight?
qqpage 21
qDoes the building have a loading dock?
Maximum access height is _____m.
qqpage 67

16 HP SureStore E Disk Array XP512: Site Prep Guide
Site Planning Timetable
The following guidelines can be used to monitor the progress of your
preinstallation preparation. The time between placing an order to actual
arrival can vary, and we recommend conferring with your HP
representative to determine the best estimated delivery dates for preparation
of your site.
The following are items that may require several weeks of lead time to
complete:
• arranging for an electrician
• adding or modifying air conditioning
• building alterations
• placing an order for data comm equipment
Due to potential delays, we recommend that the suppliers of the listed
services be contacted as soon as you have placed your order:
• Schedule the site planning visit with your HP CE to discuss questions
concerning site planning.
• Select an appropriate location for the disk array and create a plan
outlining the physical arrangement of the equipment, including related
furniture.

17
3
PREPARING FOR INSTALLATION
This chapter provides information for planning and preparing your site
before and during installation of your HP SureStore E Disk Array XP512.
Before installing your HP SureStore E Disk Array XP512, your site data
center computer room must meet the requirements described in these
sections:
• “Safety Requirements” (page 18)
• “General Computer Room Requirements” (page 19)
• “Physical Requirements” (page 21)
• “Service and Cable Routing Space Requirements” (page 27)
• “Data Comm Requirements” (page 38)
• “Electrical Requirements” (page 41)
• “Uninterruptible Power Supply (UPS)” (page 58)
• “Delivery Space Requirements” (page 67)

18 HP SureStore E Disk Array XP512: Site Prep Guide
Safety Requirements
The following sections contain information to help you properly prepare
your facility for the arrival of your disk array.
Site Safety Consideration
When making decisions concerning site safety, your first concern should be
the safety of your personnel and then the safety of your equipment. Two
major safety considerations for any computer site are fire safety and
emergency power-off. If you have any questions on site safety, consult your
HP CE, your insurance carrier, and local building inspectors for safety
recommendations.
Fire Safety
When considering fire safety, consult your insurance carrier and fire
department for suggestions and recommendations. They can analyze your
existing fire control systems, and advise you of any changes that may be
needed. If you are building a new site, or modifying an old site, consult
your local building codes for fire prevention and protection guidelines. You
can also consult your local HP CE and local fire inspectors for additional
information.
Equipment Servicing Hazards
You and your HP CEs and HP ASEs require safe access to the disk array.
Along with the specifications listed in “General Computer Room
Requirements” (page 19), ensure that electrical or data communication
cables do not create a safety hazard.

Preparing for Installation 19
General Computer Room Requirements
The goal of a computer room is to maintain an ideal environment for your
computer equipment, including your HP SureStore E Disk Array XP512.
The following guidelines are recommended:
• Locate the computer room away from exterior walls of the building to
avoid the heat gain from windows and exterior wall surfaces.
• When exterior windows are unavoidable, use windows that are double
or tripled glazed and shaded to prevent direct sunlight from entering
the computer room.
• Maintain the computer room at a positive pressure relative to the
surrounding spaces to reduce introduction of contaminants.
• Use a vapor barrier installed around the entire computer room
envelope to restrain moisture migration.
• Caulk and vapor-seal all pipes and cables that penetrate the envelope.
• Use a 10-inch to 12-inch raised floor system for the most favorable
room air distribution system.
Space planning
A site prep begins with your existing floor plan. The location of the new
equipment should be selected and a new floor plan should be developed.
You can use this section to satisfy the disk array physical requirements,
ensuring that your site is ready when the disk array arrives. Your floor plan
should include the location of:
• walls
• cable paths, including lengths
• all equipment in your computer room, including furniture, cabinets,
racks, data comm equipment, and systems
• electrical outlets
• immovable objects
• floor vents

20 HP SureStore E Disk Array XP512: Site Prep Guide
The HP SureStore E Disk Array XP512
Your HP SureStore E Disk Array XP512 has the following major hardware
components:
• one disk controller (DKC)
The single DKU contains the control panel, connection hardware, the
service processor, and control boards for the disk arrays.
• one to six disk array frame units (DKU)
The DKUs contain your disk drives; up to six DKUs may be included
in your HP SureStore E Disk Array XP512.
• one remote console PC (optional)
The remote console PC is attached to your disk array by a private local
area network (LAN). The remote console PC runs applications that
allows you to monitor and manage the disk array operations.