HP JG602A User manual

Mounting brackets installed on the power supply side
Mounting brackets installed on the port side
To access documentation and support services, go to the Hewlett Packard
Enterprise Support Center website:
www.hpe.com/support/hpesc
Documentation
Applying tamper evidence labels
Before applying tamper evidence labels, use alcohol-based cleaning pads
to clean the chassis. Allow the cleaned area to air dry for 5 minutes.
Make sure the chassis temperature is above 10°C (50°F).
Apply tamper evidence labels to all field replaceable units (such as the
FIPS enclosure, cards, the CF card, interface cards, power supplies, and
fan trays), USB ports, and any screws on an opacity shield.
If the device is to be installed in a rack, HPE recommends that you apply
tamper evidence labels before installing the device in the rack.
The tamper evidence labels in these figures are for illustration only.
5998-3972R