HP NetStorage 6000 User manual

Desktop Conversion
HP NETSTORAGE 6000
Kit Contents:
1. Bracket assembly (2)
2. Side panels (2)
3. Panel screws (4)
4. Feet and feet screws (4)
5. Bracket screws (8)
Tools Required:
Phillips screwdriver
A. Use the screwdriver to attach two feet to each bracket assembly
A. Insert three bracket assembly screws in the holes allotted on the
side of the HP Net Storage 6000, only inserting them halfway
TIP: For this step, it may be easiest to hang the edge of the unit off the
table
A.Place the bracket over the set of screws and push it up, so the slots
engage the screws
1.
2. 4.
3.
5.
Atta h the Feet
Insert Bra ket S rews
Atta h the Bra ket

A.Completely tighten the 3 screws
B. Insert and tighten 1 additional bracket screw in the front of the unit
A.Place the side panel over the bracket assembly and push the panel
forward until the back lip is flush with the back of the unit
B. Using a Phillips screwdriver, use two screws to attach the side panel to
the mounting bracket
A.Repeat steps 2-5 with the other side of the unit
*C4483-90100*
C4483-90100
Tighten the Bra ket S rews
Atta h the Side Panel
Atta h the Other Side