Huawei E5 User manual

1
Thank you for choosing HUAWEI E5 Wireless
Terminal (Hereinafter referred to as E5).
Note:
zThe supported functions and actual appearance are subject to your
product purchased. The following pictures are displayed for illustration
purpose only. For details of your product selection, consult your service
provider.
zThis guide briefly describes the function of the E5. For the operation of
configuring the management parameters, see Help on the web
management page.
zThe E5 can be used in a reasonable closed environment such as a
handbag or laptop bag, however if there is a risk that the ambient
temperature will increase when the E5 is processing data services for a
long period, due to the E5 not being able to dissipate the heat effectively.
If this happens and as a safety precaution the E5 will switch off
automatically or disconnect. In the event of this happening please
restart your E5 as usual to restart the connection.

2
2
1
3
4
5
6
8
7
Get to Know Your E5
Appearance
No. Item
1 Screen
2 Micro SD card
slot
3 USB connector
4 Power On/Off
5 WiFi/WPS button
6 Dialing button
7 Strap hole
8 Battery_button
zWiFi: Wireless Fidelity

3
zWPS: WiFi Protected Setup
Screen
No. Item
1 Signal strength
2 Network
3
zWiFi enabled
zThe number of connected
devices
4 Internet connection
5
zNew messages
zThe number of new
messages
6 Battery power level
7 Roaming status
8 zM: Manual mode

4
No. Item
zD: On Demand mode

5
Install the SIM Card and Battery
Position the card at the card slot entrance, making sure it is facing the
same way as shown in the diagram, with the notched corner at the top left.
Then slide in.

6
How to Access the Internet with WiFi
Note: By default, the management parameters are preset on the E5
according to the requirements from the service provider. You can follow
the steps below to quickly access the Internet. For the details about how to
set the management parameters, see the Help on the Web management
page.
Step1: Power on the E5
Step2: Establish the WiFi Connection
Step3: Access the Internet
1. Power on the E5
Press and hold until the screen

7
becomes lightened; the E5 is powered on.
Note: Press and hold until the screen is off; the E5 is powered
off.
2. Establish the WiFi Connection (Take PC for Example)
1. Make sure that the WiFi is enabled.
2. Select Start > Control Panel >
Network Connections > Wireless
Network Connection.
Note: To set up a WiFi connection, the PC
must be configured with the wireless network
adapter. If the wireless network connection is
displayed, the wireless network
adapter is available. Otherwise, you
should check your wireless network
adapter.
3. Click View available Wireless

8
Networks to display the wireless network connection list.
4. Select the network connection that the SSID is the same as that of the
E5, and then click .
Note:
zIf the encryption parameter is set for the E5, the Wireless Network
Connection dialog box is displayed and requires the network key and
confirmation.
zThe SSID and key label is attached on the E5.
Wait for a while. The wireless connection icon displays in the status area in
the lower right corner of the screen. Then, your PC can connect to the E5.

9
3. Access the Internet
After you establish the WiFi connection successfully, you can access the
Internet using the following two modes. By default, the mode is On
Demand.
Mode Operations
On
Demand
After the E5 is powered on, it can automatically connect
to the Internet when data transmission is required. If
data transmission is not performed over a period of time,
the E5 automatically tears down the Internet connection.
Manual
Press and hold
CONNECT
, until
is displayed on the screen,
the connection is set up
successfully. Then you can use
the Internet service.

10
Mode Operations
Press and hold
CONNECT
until is off, the connection is
tore down.
Note: You can also launch web management page to
connect to or disconnect from the network following the
prompts.
Note:
zYou can launch the web management page to select the mode of
accessing the Internet.
zIf the E5 accesses the roaming network, the E5 automatically tears
down the established network connection. While in the roaming network,
you can only press and hold
CONNECT
to establish or tear down the
network connection.
zThe dialing button dose not work in the On Demand mode.