Hutech KAI GTS9 User manual

GTS9(HT-K05A, K05B )
ASSEMBLY GUIDE

TABLE OF CONTENTS
Stand Assembly ------------------------------- 5
Side panel Assembly ------------------------------- 6
Speaker Unit Assembly ------------------------------- 9
Back Cover Assembly ------------------------------- 10
Footrest Assembly ------------------------------- 12
Basic Operation ------------------------------- 13

Main Body
P.3

Component
P.4

1. Stand Assembly
2. Connect the IR sensor connector. (Use cable ties to secure depending on
connection line status)
1.Connect power to the
massage chair so that the
stand is in its original
posture.
P.5
Connector
3. Secure with 3 stand screws

1.Connect the 3 airbag hoses (1 /2 /3 ) and two connectors
2. Side Panel Assembly
3
2
1
1
2
3
P.6

2. Side Panel Assembly
P.7
2. Hang on the side panel bracket joint and push in the direction of the arrow to join
※ Connect bracket first and join bracket. (#1,2 Same join method)
3. Press down and join the side panel in the
direction of the arrow.
1
2
12
3
2
1
12

2. Side Panel Assembly
P.8
4. Tighten the side panel fixing screw using a 6MM of allen wrench. 5.Cover the connection by
attaching the airbag part and the
connector cover (nonwoven
fabric)

3. Speaker Unit Assembly
P.9
1.After connecting the
speaker cable left and right,
secure it with a cable tie to
the airbag cable so that it
doesn’t get in the way
2. Align the position of the lower part of unit and the upper part of the side panel
and push it diagonally downward.

4. Back Cover (Top) Assembly
1.Join the top of the Back Cover with a fixing screw. And combine the speaker device with a fixing screw as well.
2.Place the back cover in the lock position and pat to combine
P.10

5.Back Cover (lower side) Assembly
1. Push the back cover (bottom) into
the lower fixing frame of the massage
chair to secure the lower part.
P.11
1-1
1-2
2.Match the position of the back cover and
gently tap to combine it.
3.Secure it with
four screws

6. Footrest Assembly
2. Connect the footrest joint, insert one directional clip, and then join the other
side.
P.12
1.Combine the airbag cable with
the connector (Check the direction
accurately when connecting
connectors

6. Basic Operation
P.13