HYCO HANDYFLOW POINT OF SE
WATER HEATER
HF05LQ
Thank you for purchasing the Hyco Handyflow point of use water heater. The unit
comes pre-wired and complete with tap and spout. The unit also has an auto-reset
thermal cut-out eliminating the need to change thermal fuses making it particularly
useful if the unit is likely to be drained frequently. lease read and understand these
instructions before commencing installation, and leave them with the user when
installation is complete.
3. ELECTRICAL INSTALLATION
The Electrical Installation must be carried out by a qualified electrician in accordance
with the current edition of the I.E.E.Wiring Regulations.
• Only connect the heater to a single phase supply with a mains voltage as specified on the
rating plate.
• Electrical connection must be made to the fixed wiring of the property by means of a 13A
fused spur. The installation must be fitted with an isolating switch, with a break contact
distance of at least 3mm.This appliance must be earthed.
• The unit is supplied pre-wired. If the cable needs replacing, it must be replaced with a
correctly rated cable and any work should be carried out by a competent person.
• Due to the auto-reset function of the thermal cut-out, this appliance must not
be used in conjunction with a timer.
4. OPERATION
• Open the inlet tap fully until water flows smoothly from the spout then close. Do not
switch power on until unit is full.
• Switch on power to the unit and select the desired temperature setting1.The indicator is lit
when the element is on.
• The unit is fitted with an auto-reset thermal cut-out which will operate for safety reasons in
the event of the unit over heating.To reset the thermal cut-out switch off the power to the
unit and allow it to cool down. Ensure the unit is full, and then switch the unit back on.The
thermal cut-out should reset itself.
1. INSTALLATION (WALL MO NTING)
• The unit comes complete with wall mounting bracket. Mount the bracket in the
required position (see Fig 1), and then hook the unit onto the bracket.
2. PL MBING
• The Handyflow must be installed vertically, with
water connections at the bottom of the unit.
• The supplied inlet tap should be fitted to the
right hand side connection (Blue) and the spout
to the left hand side (Red). See Fig 2.
•TThhee oouuttlleett ssppoouutt iiss tthhee vveenntt ffoorr tthhee uunniitt aanndd sshhoouulldd nnoott bbee rreessttrriicctteedd.. lleeaassee
eennssuurree tthhaatt oonnllyy ooppeenn oouuttlleett ffiittttiinnggss aarree uusseedd wwiitthh tthhee HHaannddyyffllooww ssoo tthhaatt tthhee
uunniitt iiss nnoott pprreessssuurriisseedd..
• Open inlet valve and check water flows smoothly from the spout before proceeding to
electrical installation.
As with all water heaters of this type, cold water entering from the inlet valve displaces
the hot water stored in the tank. it is normal for the spout to drip slightly during the
heating cycle, caused by the water expanding as it heats up. Over-tightening the tap
will not stop the dripping and may result in damage.
OFF
Frost protection. Element will switch on when water
temperature falls below 7°C
Heats water to approx 25°C
Economy position. Heats water to approx 55°C
Max temperature approx 80°C
✽
●
EE
1Operating the unit at a lower temperature can reduce scaling, save energy and reduce the risk of scalding
