iBeam TE-FTGCHD User manual

!
!
!
TE-FTGCHD (CCD)
TE-FTGC (CMOS)
FORD F150 (2004-2014)
Excludes 2004 Heritage model
Replacement Tailgate Handle with
Camera
Removal and Installation Instructions
Tools Needed: T30 torx bit, ratchet, 10mm
socket.

NOTE:Some trucks will have 6 or 8 torx screws
on bed liner cover
(If equipped).
1. Start by lowering the tailgate and remove the
(6 or 8) T30 torx screws from the bed liner,
remove liner.
NOTE: if your truck doesn’t have a liner please
advance to the next step
2. You will see (2) torx screws on the tailgate
access panel. These must be removed to gain
access to the tailgate handle.
3. After the removal of the (2) T30 torx screws,
remove the tailgate access panel and place
aside.
4. Now that you have access to the handle, you
will see (2) 10mm nuts securing the handle in
place, remove these nuts.
5. Gently remove handle by lifting the handle
from the outside and slowly working it out.

6. Now that the handle is out of the tailgate, you
will have to swap the locking mechanism out of
the old handle to the new one.
7. Start by removing the securing pin on the
locking mechanism, and then remove
mechanism from handle.
8. Now place the locking mechanism in the new
handle and secure it with the new securing pin.
9. Next, remove taillight and splice the red power
wire from the camera’s harness into the
reverse light’s 12v positive wire. This will
trigger the camera to turn on when vehicle is
placed in reverse. Attach the black ground wire
to a metal non-painted surface.
10. Wires can now be fully routed from the tailgate
to the cab of the truck and to a video source.
The Yellow RCA will plug into the input of your
video source; the Red wire goes to the rear
camera input trigger wire on your video
source.
NOTE: Test to make sure video is working
before securing new handle.

NOTE: If desired parking lines can be removed
by attaching the green wires together.
11. Now gently reinsert new tailgate handle (avoid
pinching cable running to camera).
12. Realign the handle’s post with the tailgate’s
opening mechanism and reattach 10mm nuts
to secure handle in tailgate.
13. Reattach the tailgate’s access panel and bed
liner cover to complete your install.
!!!!!!! !
!
1.800.221.0932!
www.iBeamUSA.com!
460!Walker!Street,!Holly!Hill,!FL!32117!