iBeam TE-JPKT User manual

TE-JPKTManual

1. Box Contents
Camera and wiring Bracket 2 Push nuts
•Applications
2007-2018* Jeep Wrangler (*2018 JK trim only)
•Installation of camera
•Run camera wire through stem of bracket, DONOT pop the camera
into the bracket before confirming visual onmonitor.
•Connect the RED wire to a 12V reverse trigger.
•Connect the BLACK wire toa chassis ground.
•If reverse signal is needed in the front of vehicle, RED wire with RCA
will provide that signal from the red wire inthe rear ofthe vehicle.
•If parking lines are needed, please cut the white loop on the harness.

4. Wiring diagram
5. Specifications
Sensor
CMOS 7080
Resolution
480 TV Lines
Field of view
Diagonal 170º, Horizontal 110º, Vertical 90º
Illumination
0.6 Lux
IP rating
IP67
Parking Lines
Defeatable (white loop on harness)
Extension cable
26’
TV system
NTSC
Working Temp
-20ºC ~ 70ºC
Warranty
3 years
2 ft
22 ft

IMPORTANT
If you are having difficulties with the installation of this product, please call out
Tech Support line at386-257-1187.Before doing so, looks over the instructions a
second time, and make sure the installation wasperformed exactly asthe
instructions are stated. Please have the vehicle apart and ready toperform
troubleshooting steps before calling.
REV. 02/21/2020
386-257-1187