iBeam TE-RM45 User manual

TE-RM45 User Manual
iBeamUSA.com
MetraDealer.com
[e-mail]
� TECH SUPPORT
l ::: J 800-253-8324

1
1. Mirror
2. OE Brackets
3. Specification
Power consumption 4W
Working voltage DC10-15V
Video input AV1, AV2 (reverse camera)
Signal system PAL / AUTO / NTSC
Screen size 4.5 inch
Frameless TFT LCD panel
Ultra high brightness 1700cdm
480(H)xRGBx272(V)
16:9 / 4:3
Display screen
Brightness
Display resolution
Display mode

2
4. Operation
(1) The screen only works when it has video signal going into it. When AV1 input receives signal,
the screen turns on to AV1. When the signal is removed, the screen turns off.
(2) When AV2 receives video signal, the screen powers on and switches to AV 2, regardless of
whether there is signal going into AV1. When signal is removed from AV2, either the screen will
switch to AV1 if there is signal present there or switch off there is no signal.
(3) The screen can adjust its brightness according to the ambient light condition. When ambient light
is strong, the screen will be brighter. Similarly, the screen will decrease its brightness to protect
your eyesight and so it isn’t too bright while driving when the ambient light is low.
5. General Instruction
This rear view mirror monitor is designed for car rear view purpose, which can work with a reversing
camera (NTSC or PAL) to show the real-time image behind your car. When the reverse gear is
engaged, the rear view system automatically starts to work, and when the monitor is powered off, the
mirror functions just like a normal rear view mirror as the monitor is hidden and almost invisible.

IMPORTANT
If you are having difficulties with the installation
of this product, please call our Tech Support line
at 1-800-253-TECH. Before doing so, look over
the instructions a second time, and make sure
the installation was performed exactly as the
instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting
steps before calling.
When connecting with power cable, please make sure not to mistake the positive and
negative pole, otherwise the fuse will blow immediately for security protection.If ithappens,
please replace the blown fuse with a new one with same specification, after connecting
properly to the right pole. Don’t randomly increase the current rating of the fuse, and NEVER
use metal wire asa substitute.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Version 1.0