ICP DAS USA M2M-710D Installation guide

1
TM
M2M-710D
FAQ
Version 1.01

2
Table of Contents
Q1: If I forget the M2M-710D’s IP, how can I set and operate the M2M-710D by web
browser? ............................................................................................................................ 3
Q2: Client cannot connect to Server. ................................................................................. 4
Q3: Server and Client can’t establish Com Port connection.............................................. 6
Q4: Why can not the PC of user connect to M2M-710D in VxComm mode? ................... 7
Q5: What kind of version does the VxComm driver support M2M-710D on user’s PC? .. 7
Q6: Why can’t M2M-710D connect to VxServer after making sure that the setting of
server IP and port are correct and that the server executes VxServer?............................ 8

3
FAQ
Q1: If I forget the M2M-710D’s IP, how can I set and
operate the M2M-710D by web browser?
A1：
(1) ：Please reset system, and IP address will show again.
Display IP address
(2)：Init M2M-710D reference 2.3. Default value of IP address is
192.168.1.217

4
Q2: Client cannot connect to Server.
A2: Please follow the following steps to check that the network configuration is
correct.
Step 1: Check IP of Server and Client is the only. The IP is not the same with
the other network device.
Step 2: Please confirm the network configurations are correct. The
configurations include IP Address, Net Mask, Gateway and DNS
Server. If the configurations are all correct, it should respond to the
ping command from PC.
Net setting
Step 3: Please confirm that the following settings are correct.
¾ “Server IP” of Client is the same with “IP Address” of Server.
¾ “Communication Port” of Server and Client are the same.
¾ “Operation Mode” of Client is “Client”.
¾ “Operation Mode” of Server is “Server”.

5
Client’s “Standard Config” page
Server’s “Standard Config”page

6
Q3: Server and Client can’t establish Com Port
connection.
A3: Please follow the steps to check below.
Step 1: Confirm client’s name is the same as server permission name list.
Step 2: Confirm comport setting of server and client. Server comport setting
must the same setting as client.
Comport setting of server

7
Comport setting of client
Step 3: Does the inspection wiring have the question?
Q4: Why can not the PC of user connect to M2M-
710D in VxComm mode?
A4: Please confirm the mask address. The mask address of PC and M2M-710D must
be the same. Like 255.255.0.0
Q5: What kind of version does the VxComm driver
support M2M-710D on user’s PC?
A5:
Above Vxcomm driver version as v2.9.13
Above M2M-710D’s firmware version as v13

8
Q6: Why can’t M2M-710D connect to VxServer after
making sure that the setting of server IP and port
are correct and that the server executes VxServer?
A06: Please make sure M2M-710D is the same domain with gateway, or change "Boot
protocol" into DHCP.