ICP DAS USA UA-5231M User manual

P.1
Packing List
The shipping package includes this document and the following items:
UA-5231 or UA-5231M
UA-5231M-3GWA
UA-5231M-4GE/4GC
CA-0910
Cable
MicroSD
Card
Screw
Driver
Pin
Terminal
x 16
M3x6L Screw x 4
44mm DIN-Rail Clip x 1
(UA-5231M, UA-5231M-4GE/4GC,
UA-5231M-3GWA Only)
GSM Antenna
(ANT-421-04)
(UA-5231M-4GE/4GC,
UA-5231M-3GWA Only
Technical Resources
How to search for drivers, manuals and spec information on ICP DAS website.
For Mobile Web
For Desktop Web
UA-5200 Series Quick Start
v1.5, 05/2020
Technical Support
[email protected]
www.icpdas.com

P.2
1. Preparations for Devices
1. Power Supply: +12 ~ +48 VDC (Ex: DP-665)
2. Ethernet Hub or Switch (Ex: NS-205)
3. PC/NB: Can connect to the network and set the network
2. Hardware Connection
Connect the UA-5200 with the RJ-45 Ethernet port to an
Ethernet hub/switch and PC. You can also link directly the
UA-5200 to PC with an Ethernet cable.
After power is connected, please【wait 1 minute】for UA-5200
start-up procedure. When the "RUN/PWR" light starts flashing,
it represents the boot is complete.
Power Supply
(12 ~ 48 VDC)
VS+
GND
Ethernet
Cable
Ethernet
Cable
Hub/Switch
P.GND
PWR

P.3
3. Network Connection
Factory Default Settings of UA-5200
Network
IP
192.168.255.1
Assign UA-5200
a new IP setting
according to your
case.
Netmask
255.255.0.0
Gateway
192.168.1.1
OS
Account
Username
root
After login,
change your
password ASAP.
(Refer User
Manual)
Password
icpdas
Web UI
Account
Username
root
Password
root
1. Change the PC’s IP setting as following.
(Write down the PC original network settings before modify.)
IP
192.168.255.10
Subnet mask
255.255.0.0
Gateway address
192.168.1.1
2. Make sure the PC and UA-5200 is connecting through
Ethernet. And then open a PC side browser. (Ex: Chrome,
IE…)

P.4
3. Type http://192.168.255.1 in the URL address. Use default
Web UI username/password root/root to login the system.
4. Click【System Setting】【Network Setting】【Network
Setting(LAN1)】to change the IP setting by user network.
5. Save the IP setting, restore the PC original IP settings, and
type the new IP in the browser as step-3 to login the Web UI
of UA-5200. And then configure user’s UA project.