IDEAL OF SWEDEN QI User manual

QI CHARGER
USER MANUAL
Gamla Rådstugugatan 33, 602 24 Norrköping, Sweden
Produced in China.
IDEAL OF SWEDEN AB. All rights reserved. The product,
packaging, logo and wordmark are intellectual proper-
ties of IDEAL OF SWEDEN AB. The use of the QI-logo
and wordmark is under license. Manufactured by
IDEAL OF SWEDEN AB.

The content of this document is for information purposes only.
IDEAL OF SWEDEN reserves the right to change this information at
any time without prior notice.
product specifications
1. Product standard: Qi standard V1.2.4
2. Output power: 5W/Supports up to 10W
3. Charging voltage/current: 5V/1AMP
4. Charging frequency: 110-205 KHz
5. Charging distance: ≤10mm
6. Maximum RF output power: 28.42 dBuA/m at
3m distance.
notes
1. This product must be used as advised, other
wise it can cause a re, explosion or other
dangers. IDEAL OF SWEDEN has no
responsibility in case of misuse or use not
compliant with the product instructions.
2. Do not place any products other than spec ied
smartphones on Qi charger, as this can cause
damage to your charger.
3. Connect the Qi charger to an appropriate
power outlet.
4. Connect the Qi charger to an easil accessible
place for easy disconnection.
5. This product is compatible with Qi wireless
charging standard V1.2.4
connecting & charging
1. Connect the supplied cable to your wireless
charger.
2. Connect the USB end into any computer or
optional wall head (must be UL or ETL).
3. Once plugged in you will see a blue led light
turn on then off.
4. Place your smartphone on charger.
5. The blue light will turn on, your phone is now
being charged. If you do not see a blue light
please move phone over the Qi charger until
you see a steady blue light.
6. Allow 4-5 hours for a complete charge.
safety information
1. Do not modify, disassemble, open, drop, crush,
puncture or shred the Qi charger.
2. When using the Qi charger, keep it away from
ammable materials.
3. Keep the Qi charger away from high (> 45°C
104°F) and low (< -20°C -4°F) temperature
environment.
4. Do not expose the Qi charger to rain or water.
5. To prevent heat build-up keep the Qi charger
away from re, heat and sunlight.
6.
Disconnect the Qi charger from the power
outlet once you are done charging your device.
7. This product is not a toy, keep it away from
children.
8. If the QI charger does not work as described
or otherwise as expected, shows any signs of
interference with the product being charged
or shows signs of being overheated, imme-
diately unplug the Qi charger and remove the
charging device.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harful
interference, and (2) this device must accept
any interference received, including interfence
that may cause undesired operation.
fcc caution
Changes or modications not expressly approved
by the part responsible for
compliance could
void the user’s authority to operate the
equipment.
fcc statement
*This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment gen-
erates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
— Consult the dealer or an experienced radio/
TV technician for help.
* This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.