idi Aspect Iso-Drive Q-CARD User manual

2501 Weston Parkway | Cary, NC 27513
Aspect Iso-Drive Q-CARD
CLEANING AND STORAGE:
1) Unplug power cord and
wrap it around the cord
holder.
2) Push in Emergency Stop
Pushbutton.
3) Lock rear casters and front
steering.
4) Clean and disinfect table.
WARNING! Read operator
manual prior to use
Scan to
Access
User
Manuals
Online
ACCESSORY RAILS
EMERGENCY
STOP BUTTON
CASTER LOCK
PEDAL
POWER CORD
HOLDER
CONNECTION PORT
FOR HAND CONTROL
(BOTH SIDES)
FRONT STEER
LOCK PEDAL
SWIVELING CASTERS
(CAN BE TOTAL LOCKED)
IMAGING END
OF TABLETOP
PEDESTAL END OF
TABLETOP
SETUP/PATIENT PREPARATION:
Moving table (NEVER WITH PATIENT ON BOARD):
1) Unlock Rear Casters using Caster Lock Pedal.
2) Unlock Front Steering using Front Steer Lock Pedal.
3) Position table to desired location.
4) Secure table mobility by locking Casters and front steering
using Rear Caster Lock Pedal and Front Steer Lock Pedal.
AC Power:
1) Plug power cord into properly grounded outlet.
2) Protect power cord from damage by casters or other
equipment.
Controls:
1) Emergency Stop Pushbutton disables all tabletop motion
control when engaged.
2) Ensure that hand control is connected to table.
3) If tabletop motion controls fail to operate, make sure that the
Emergency Stop Pushbutton is NOT pushed in.
4) Actuate controls to ascertain that power is present and table
movement functions properly.
EMERGENCY PROCEDURES:
Stop Tabletop motion:
•Press Emergency Stop Pushbutton until it is fully engaged.
AC Failure:
•Internal battery allows tabletop motions to function.
Return tabletop to proper position to unload patient.
CPR:
Return tabletop to level in both Trendelenburg and Iso-
Roll and lower table position to a comfortable height to
perform CPR.

•PUSH IN to stop
ALL tabletop motion.
•TWIST to reset.
L100-3228 Rev.C
Patients must be loaded from the side of table. Tilting or instability may occur if
patient is loaded onto the imaging end of the table.
EMERGENCY STOP
PUSHBUTTON
HOW TO STORE TABLE POSITIONS:
1. Move tabletop (Trendelenburg, roll, height) to desired
position.
2. Press the “Save Stored Position Memory” button.
3. Choose and press the desired position button (1, 2, 3).
HOW TO RETURN TO A STORED POSITION:
1. Press and hold the desired memory position button until
the tabletop has finished moving.
Aspect Iso-Drive Q-CARD
LOCK
PRESS FORWARD ON
TOP HALF OF PEDAL
TO LOCK ALL
MOVEMENT
OF REAR CASTERS
UNLOCK
PRESS DOWN ON
BOTTOM HALF OF
PEDAL TO ALLOW
REAR CASTERS TO
SWIVEL FREELY
CASTER LOCK/STEER
PEDAL POSITIONS
STEER LOCK
PRESS DOWN ON PEDAL TO
RESTRICT FRONT MOVEMENT TO
FORWARD AND BACKWARDS ONLY
FLOAT POSITION
PULL UP ON PEDAL TO ENABLE
MOVEMENT OF FRONT IN ALL
DIRECTIONS