IEI Technology PulM Series User manual

www.ieiworld.com
PulM Series
PulM-100G2SF-E810
Networking Module Quick Installation Guide
For Puzzle-IN005
PulM-100G2SF-E810
Package Contents PulM-100G2SF-E810 Block Diagram
LAN LED Status
LED State Description
Yellow Active
Speed (Right)
Link (Left)
Green 100Gbps data rate
Orange other data rate
LAN Port
Speed
LED
Link
LED
SFI 100G
note: two ports are redundancy, only one port can reach 100G
PCIe 4.0
1 x PCIe 4.0 x8
Intel® E810
QSFP28
QSFP28
A19
A32
A19
0
A32PCIe CONF. MODE
1One x8
Hardware Installation
A19 A32 PCIe Cong.
0 1 2x4
1 0 1x8
A32 A19
PCIe Conguration
x4
x8
x4
CPU
One PCIe x8 or
Two PCIe x4
Install the IEI PulM-100G2SF-E810 networking
module into the slot of the PUZZLE-IN005. All
slots support 8 lanes of PCIe gen4 signal from
CPU (one PCIe x8 or two PCIe x4).

Networking Module Installation
Loosen the two screws indicated below. Grab the
screws and pull the slot cover all the way out to
remove it.
1
Step
Slide an IEI networking module into the slot until the
module is seated in the slot correctly and securely.
Fasten the two screws on the networking module to
secure the module to the chassis.
2
Step
CAUTION:
When inserting the module, the bottom of the networking module must be as close to the slot base as possible so that the
module can be slid into the guide rails.
When removing the module, slide the module horizontally all the way until it is completely out of the system. Lifting up the
module before completely sliding out may cause the components on the module to be damaged.