iHealth HS5 User manual

Wireless Body Analysis Scale (HS5)
QUICK START GUIDE
iHealthTM
DOWNLOAD THE FREE iHealth APP
Prior to first use, download and install “iHealth MyVitals” from the App Store.
It is very important that every Scale user follows the on-screen instructions
to register and complete a personal profile because data points such as
height and age are necessary to measure body composition.
PRE-SET UP INSTRUCTIONS
• iOS device is compatible and is version V5.0 or higher.
• Wireless internet connection provided by a router is compatible with Wi-Fi
IEEE 802.11 b/g standard and supports WEP, WPA and WPA2 personal
security modes.
INSTALL BATTERIES
Open battery cover on the back of the Scale and install four “AA” batteries.
SELECT WEIGHT UNIT
Select a weight unit by adjusting the switch under the battery cover.
SET UP THE SCALE’S WI-FI CONNECTION (Prior to first use, or when
changing routers)
EN
PUSH
PUSH

STEP 1: Connect iOS device to your home Wi-Fi. (Settings->Wi-Fi->On)
STEP 2: Turn Bluetooth “On” on your iOS device and it will start searching
for the Scale.
STEP 3: Wait until the model name, “iHealth HS5xxxxx”, and “Not Paired”
appear on your device’s Bluetooth screen. Select the model name
“iHealth HS5xxxxx” to pair and connect. (Note: it may take up to
30 seconds for your iOS device to detect the Bluetooth signal)
STEP 5: The wireless signal icon on the Scale’s display will flash for a few
seconds and then stabilize when Wi-Fi connection is successful.
The Scale should display as shown below.
The Bluetooth connection will then automatically disconnect from the Scale.
Your scale is now connected to your home Wi-Fi and ready to use.
STEP 4: Select “Allow” in the pop-up window, as shown below.

MEASUREMENT INSTRUCTIONS
a. Launch the iHealth App. Step on the Scale to turn it on, and wait until
“0.0” appears on the display.
b. Stand on all four electrodes with bare feet. Your weight data will appear
on the Scale display first, followed by Body Fat %. Remain on the Scale
for a few seconds to allow the Scale to continue the measurement. If you
have socks on, the Scale will only display your weight.
The iHealth App will show detailed body composition data including Weight,
BMI, Body Fat, Lean Mass, Body Water Percentage, Muscle Mass, Bone
Mass, Visceral Fat Rating and Daily Calorie Intake (DCI).
Note: If the Body Fat measurement fails, only your weight will be displayed.

Up to 20 people can use the Scale. The Scale determines who the user is
by matching the new weight with weight previously recorded. If the weight
of two or more users is similar, the Scale will display the user number (e.g.
User # “x” ). Step lightly on the lower left corner to select the appropriate
user, and then step lightly on the lower right corner to confirm. When taking
measurements without an iOS device, your current measurement data will
be uploaded to the Cloud automatically.
Visit www.ihealthlabs.com to obtain additional product information. For
Customer Service, please call [phone].
TAKING MEASUREMENTS WITHOUT iOS DEVICE
If you switch your ISP or internet router, first press the “Set” button under
the battery cover on the back of the Scale to reset the Wi-Fi connection,
then proceed to the “SET UP THE SCALE’S WI-FI CONNECTION”
instruction steps.
Instructions for switching ISP or internet router