IKEA BESTA User manual

Assembly instructions BESTA njufront.pl
1
Assembly instructions njufront.pl panels for the
IKEA BESTA system
Content
IKEA ADDITIONALLY
NJUFRONT
Order of assembly
6x
BESTA body
Top panel
Side panels
2
1x
1
1x
3
1x
8x
1x
1x
2x
Screws –top panel
Screws –side panels
Please follow the safety instructions attached to the furniture. It is
recommended to install the BESTA bodies to the wall using the anchor
brackets supplied with the IKEA cabinet, especially in the case of high-
quality fronts.

Assembly instructions BESTA njufront.pl
2
Side panel assembly
Before mounting, make sure that the
surfaces of the elements are clean and
free from contamination.
Position the furniture body in a position,
where the rear wall is on the ground. Place
the side panel in a suitable place so that
its edges adhere to the furniture body.
Secure the panel with screws by placing
them on the inside of the body.
You can use the holes under the shelves
to attach the screws for the side panels.
When screwing the screws, press the
panel to the body with your hand. If you
have one, you can use a carpentry clamp
for this purpose.
Place the screws as evenly as possible.

Assembly instructions BESTA njufront.pl
3
Top panel assembly
Before mounting, make sure that the
surfaces of the elements are clean and
free from contamination.
Position the furniture body in a position,
where the rear wall is on the ground. Place
the top panel in a suitable place so that its
edges adhere to the furniture body.
Using a pencil to mark the location of the
screws.
Secure the panel with screws by placing
them on the inside of the body.
When screwing the screws, press the
panel to the body with your hand. If you
have one, you can use a carpentry clamp
for this purpose.
Place the screws as evenly as possible.
Top
panel
.
.
.
.
.
.

Assembly instructions BESTA njufront.pl
4
During assembly
Cleaning
Before assembly, the surfaces of the elements should be cleaned with a soft,
damp microfiber or cotton cloth.
Avoid using bristles with hard bristles; abrasives in the form of pastes and
powders; sponge for scrubbing and sharp cloths.
Avoid using undiluted or concentrated detergents with a strong effect; acetone,
ammonia, alcohol and other abrasives cleaning agents.
Surfaces should be regularly cleaned with a soft, damp microfiber or cotton
cloth, using a mild cleaning solution for painted surfaces. After cleaning, wipe
the front with a damp cloth and wipe dry.
When assembling panels and fronts, avoid shocks with hard or sharp objects
that may permanently damage the surface of the varnish.
Avoid exposing the surface of painted parts to contact with sharp objects.
Avoid bumping the elements against the ground. When laying down the
elements, soft-material should be used to protect them against damage.
Do you have questions or concerns about assembly? Contact us by phone 606
402 112 or by e-mail [e-mail]. We will try to help.