iLive ISA33B User manual

Plug the included AC/DC power adapter into
the DC POWER INPUT to power the base
station.
AUX IN DC IN 5V
USER’S GUIDE
V: 421-02
ISA33B Wireless Speaker System
Warning: Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The apparatus shall not be exposed to dripping or splashing and that no objects lled with
liquids, such as vases, shall be placed on apparatus.
L’appareil ne doit pas être exposé aux écoulements ou aux éclaboussures et aucun objet ne
contenant de liquide, tel qu’un vase, ne doit être placé sur l’objet.
• Main plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mains plug should
be disconnected form the mains socket outlet completely.
La prise du secteur ne doit pas être obstruée ou doit être facilement accessible pendant son
utilisation. Pour être complètement déconnecté de l’alimentation d’entrée, la prise doit être
débranchée du secteur.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à la lumière du soleil, au feu
ou autres choses de semblable.
• Caution marking is located at the rear or bottom of the apparatus.
Attention marquage est situé sur le paneau arrière ou inférieur de l’unité.
• The marking information is located at the rear or bottom of apparatus.
Le marquage est situé sur le paneau arrière ou inférieur de l’unité.
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding - type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The
wide blade or the third prong are provided for your
safety. When the provided plug does not t into your
outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the
manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table
specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over. Unplug this apparatus during lightning
storms or when unused for long periods of time.
13. Refer all servicing to qualied
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such
as power-supply cord or plug is
damaged, liquid has been spilled
or objects have fallen into the
apparatus, the apparatus has
been exposed to rain or moisture,
does not operate normally, or has
been dropped.
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• WARNING:To reduce the risk of re or electric shock, do not expose this apparatus to rain or
moisture.
• AVERTISSEMENT: Pour réduire le risque d’incendie ou de choc électrique, ne pas exposer cet
appareil sous la pluie et l’humidité.
• CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or
sensitive nish. As with any rubber compound made with oils, the feet could cause marks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• WARNING: Use of this unit near uorescent lighting may cause interference regarding use of
the remote. If the unit is displaying erratic behavior move away from any uorescent lighting, as
it may be the cause.
• CAUTION:Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
• PRÉCAUTION: Danger d’explosion si les piles sont remplacées de façon incorrect. Remplacer les
piles seulement par le même type de pile ou l’équivalent.
• WARNING: There is a danger of explosion if you attempt to charge standard Alkaline batteries in
the unit. Only use rechargeable NiMH batteries.
• WARNING: The remote control’s button cell battery contains mercury. Do not put in the trash,
instead recycle or dispose of as hazardous waste
• WARNING:Lithium batteries, like all rechargeable batteries are recyclable and should be recycled
or disposed of in normal household waste. Contact your local government for disposal or recycling
practices in your area. They should never be incinerated since they might explode.
• WARNING: Shock hazard - Do Not Open.
• AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS OUVRIR
Mains plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mains plug should be
disconnected form the mains socket outlet completely.
La prise du secteur est utilisé pour déconnecter le système.
La prise du secteur ne doit pas être obstruée ou doit être facilement accessible pendant son
utilisation. Pour être complètement déconnecté de l’alimentation d’entrée, la prise doit être
débranchée du secteur.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
No mezcle baterías viejas y nuevas.
No mezcle baterías alcalinas, estándar (carbono-zinc) o recargables (ni-cad, ni-mh, etc.).
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
ATTENTION
RISQUE D' ÉLECTROCUTION
NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
This symbol indicates that this product
incorporates double insulation between hazardous
mains voltage and user accessible parts.
The lightning ash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may
be of sufcient magnitude to constitute a risk of
electric shock to persons.
IMPORTANT SAFETY INSTRUCTIONS
Introduction and Setup
FCC Warnings
Power
Power the wireless speakers by connecting
them to a standard AC outlet using the
attached AC power cable.
The AC power cable is stored inside of the
wireless speaker’s battery compartment.
After extending the AC power cable out from
the battery compartment, snap the battery
compartment door back into position to keep
the internal elements of the wireless speaker
from being exposed.
Speakers - Power
Additional Warnings
WARNINGS AND PRECAUTIONS
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com Customer Service: 1-888-999-4215
Email Support: [email protected], Email Parts: [email protected]
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
Requires 6, D size, batteries (not included).
Speakers - Battery Power
PAIR
LINK
POWER
OFFON
AUX IN DC IN 5V
PAIR
Press to pair
the base station
with the wireless
speakers.
POWER
Adjust to turn the
power on and off.
LINK INDICATOR
Blinks when pairing
with a wireless
speaker.
Lights when paired
with a wireless
speaker.
DC POWER INPUT
3.5MM AUDIO
INPUT
BATTERY
COMPARTMENT
Requires 6 D
batteries, not
included.
AC POWER CORD
Use to connect the
wireless speaker to a
standard AC outlet.
LEFT/RIGHT/MONO
Adjust to switch
between Left, Right,
and Mono speaker
modes.
POWER
Press to turn the
speaker off and on
PAIR
Press and hold to
pair the speaker with
nearby base stations.
SPEAKER VOLUME
Turn to adjust the
volume of the wireless
speaker.
LINK INDICATOR
Indicates the current
status of the wireless
speaker’s link with the
base station.

Pairing the Wireless Speaker with the
Base Station
3.5mm Audio Input
Link Indicators
Transmission Range
Using the 3.5mm Audio Input
To download this User’s Guide in English,
Spanish, or French, or to get answers to
frequently asked questions, visit the support
section at: www.iLiveElectronics.com
Para descargar este Manual del Usuario en
inglés, español y francés, o para obtener
respuestas a preguntas frecuentes, visite la
sección de apoyo en www.iLiveElectronics.
com
Pour télécharger ce guide de l’utilisateur en
anglais, espagnol ou français, ou pour obtenir
des réponses à des questions fréquemment
posées, consultez la rubrique d’assistance
sur www.iLiveElectronics.com
International Support
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com Customer Service: 1-888-999-4215
Email Support: [email protected], Email Parts: [email protected]
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
Off
Powered off.
Slow Flashes
Standby mode.
Quick Flashes
Attempting to pair.
Solid Light
Paired and playing.
If the base station is not playing audio, then
both the base station and wireless speakers
will go into Standby mode. Once you begin
playing audio from the base station, both the
base station and wireless speaker will come
out of Standby mode.
Once the base station is paired with a
wireless speaker, the wireless speaker can be
moved approximately 200ft (line-of-sight) or
approximately 90ft (indoors) and still receive
audio from the base station.
Results will vary depending on the number
and size of obstructions between the base
station and the wireless speaker.
1. Plug the base station into a power
source, and press the POWER button to
power the base station on.
2. The base station LINK INDICATOR will
ash when the base station is powered
on.
3. Plug the wireless speaker into a power
source or insert 6 D batteries, not
included, and press the POWER button
to power the wireless speaker on.
4. The wireless speaker LINK INDICATOR
will ash when the wireless speaker is
powered on.
5. Adjust the VOLUME on the wireless
speaker to approximately the half-way
point between min. and max volume.
6. Press & Hold the PAIR button on the
base station until the LINK INDICATOR
ashes quickly, then press & hold the
PAIR button on the wireless speaker.
7. The wireless speaker will emit a long
beep when it is paired with the base
station.
If the wireless speaker emits short
repeating beeps, it was not able to pair
with the base station. Repeat steps 1-4
until you hear the long beep.
After pairing, the wireless speaker may
take up to 30 seconds to begin playing
audio from the paired base station.
Repeat steps 1-4 for each additional
wireless speaker you want to pair with
the base station.
The two wireless speakers included in the
same box as the base station are pre-
paired with that base station. Any additional
speakers will need to be paired by following
the directions below.
When pairing the base station with a wireless
speaker you will need to press the Pair button
on the base station and wireless speaker
simultaneously. Because of this, you will need
to have both the base station and wireless
speaker within reach when you pair them.
What does it mean to Pair?
Pairing the base station with a wireless
speaker allows the base station to
recognize that wireless speaker. Once
paired, the base station will remember
that wireless speaker and transmit audio
through it.
Before Pairing
Pairing Requires a 3.5mm audio cable (included)
Also included is a 3.5mm to stereo RCA
adapter.
1. Connect a 3.5mm audio cable to the
3.5MM AUDIO INPUT on the side of the
base station and the audio source.
2. Use the connected audio source’s
native controls to play and control music
played through the connected base
station and linked wireless speakers.