Crux SWRVL-54 User manual

-Retains factory features in select Volvo vehicles while functioning with an aftermarket radio.
- Retains Steering Wheel Controls via built-in, pre-programmed interface
-Supports amplified and non-amplified systems.
-EIA color coded wiring for easy installation.
VOLVO
2001 - 2004 S40
1999 - 2009 S60
1999 - 2005 S80
2001 - 2004 V40
2001 - 2007 V70*
2001 - 2007 XC70*
2002 - 2012 XC90*/**
1. *Compatible with CAN based vehicles only (2nd Generation / Type P26).
2. ** NOT Compatible with LIN bus and Fiber-optic systems. Please verify prior to installation.
rev.041917
1/2
VL-54 Module
VL-54 Harness

SETTING THE AFTERMARKET RADIO BRAND
This step is only necessary if the vehicle has steering wheel controls and you are installing one of the radios listed. With
the key in the off position, set the DIP switches to the corresponding radio listed below.
3.5MM SWC CABLE
The SWRVL-54 Module allows for both types of connections:
OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached)
OPTION B is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and
SOUND STREAM units.
NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
BOSS Radio SWC Programming
SWC Radio Wiring connection
SWC Key1 (Brown-wire) connect to Female 3.5 mm Jack - Brown wire
SWC Key2 (White-wire) connect to Female 3.5 mm Jack - Brown/White wire
SWC GND (Black-Wire) connect to Radio Negative wire (Black)
Programming the Radio
Press: [SETTING] > [STEER] > [RESET] > [High Z]
Press the Steering Wheel Control (SWC) buttons set the values as listed below:
Vol –[ 4.07]
Vol + [ 3.66]
Seek –[ 3.37]
Seek + [ 2.98]
Mode [1.39]
OFF Hook [ 0.00]
The Value in the bracket [X.XX] will vary and will be used as parameter for each assigned function.
Press: [Assign] > [4.07] > [Vol-], then the [4.07] will be replaced with [ Vol-]
With [Assign] highlighted:
Press: [3.66] > [Vol+], then the [3.66] will be replaced with [Vol+]
Press: [3.37] > [Seek-], then the [3.37] will be replaced with [Seek-]
Press: [2.98] > [Seek+], then the [2.98] will be replaced with [Seek+]
Press: [1.39] > [Mode], then the [1.39] will be replaced with [Mode]
Press: [0.00] > [Call], then the [0.00] will be replaced with [Call]
Press: [Enter] for Save the setting and Exit
USING A RELAY
The module is rated at up to 2A max power output. For
applications demanding a continuous output of 3A or more,
we recommend using a standard Bosch (SPDT) relay.
rev.041917
2/2