CHILD
WITH INBUILT HARNESS
INSTALLATION
Safe Grip (Red belt clamp)
in position
Layer of foam
& seat cover
placed back
into position
over the top
of the belts
NOTE: Shown with in
built harness cut away
Lap and sash
belts pass
across the base
Push down on the base of the restraint (with knee or
hand) whilst pulling the sash section of the vehicle
belt rmly up in direction of the yellow arrow in gure
5. This will make the lap belt very tight across the
seat base. Whilst continuing to pull the sash section
up (i.e maintaining tightness of the lap section) attach
the Safe Grip (red belt clamp) on the sash section as
close as possible above the buckle tongue. (Refer to
Figure 8 and instruction for installing the Safe Grip
red belt clamp below) Tighten sash section of belt
across the base. Place layer of foam and seat cover
back into position over the top of the vehicle belt.
Step 6:
Pull sash section up
firmly before placing
Safe Grip (red belt clamp)
in position
Safe Grip
(red belt clamp)
Sash section
of vehicle belt
PRESS SEAT
BASE HERE
Figure 6
Figure 7
Figure 5
SAFE GRIP BELT CLAMP
The Safe Grip (red belt clamp) locks the lap
belt to ensure a rm installation, and avoids
slack in the lap belt.
To install the Safe Grip (red belt clamp), open it
and clamp the “sash section” of the vehicle seat
belt by closing the barrel section of the red belt
clamp in the direction of arrow 1 in gure 8 and
then locking with the toggle section by pushing in
the direction of arrow 2 in gure 8 when the Safe
Grip (red belt clamp) is secured in place, the lap
section is now tightly holding your child restraint
in place, independent of the sash section. The
Safe Grip (red belt clamp) must be removed
when the child restraint is not installed to allow
other users to use the seat belt as a lap/sash seat
belt. Always keep the Safe Grip (red belt clamp) in
pocket provided when not in use.
(Using Lap-sash Seat Belt)
Follow the instructions covered by “Installing in
Vehicle (Using lap sash seat belt)” Steps 1 to 6 (refer
pages 11 & 12).
Note: Do not use the Safe Grip (Red belt clamp) as
there is no sash section of the seat belt.
Step 1:
(Using Lap Seat Belt)
Tighten
sash belt
across base
TOGGLE
SECTION (2)
LAP SECTION
BARREL SECTION (1)
SAFE GRIP (B)
(red belt clamp)
ATTACH TO
SASH SECTION
ONLY
SASH SECTION
BUCKLE (A)
(AND TONGUE)
Figure 8
14