Ingersoll-Rand Schlage ND Series User manual

ND-Series Tailpiece Install Sheet
1
Classic Cylinder Shown
View of Back of Cylinder
Remove Cylinder Cap
a. Depress cap pin and rotate
cap counterclockwise.
b. Remove cap from cylinder.
c. Remove existing tailpiece.
Use this sheet and the included tailpieces to retrofit an existing
cylinder with an ND-Series tailpiece.
Cap Pin
Tailpiece
Cap Pin
Tailpiece
(N523-023 shown)
Cylinder
Cap
Key

2
3
Classic Cylinder Shown
Cap
Tailpiece
N523-023 – For ND-Series
Classic Cylinder
N523-022 – For ND-Series
Everest or Primus Cylinder
Install New Tailpiece
a. Place new tailpiece (in the
vertical position) against back
of cylinder.
b. Place cap over tailpiece.
c. Depress cap pin and rotate
cap clockwise until tight.
IMPORTANT
If key does not come out of cylinder easily, cap is too lose.
If key does not turn smoothly in cylinder, cap is too tight.
Select New Tailpiece
Graphic shown actual size
©2003 Ingersoll-Rand Company
Printed in U.S.A.
Rev. 06/03