Inter-m RM-01 User manual

RM-01
Remote Microphone

Remote Microphone
The RM-01 is an ideal remote paging microphone with push-to-talk and push-
to-chime control. It features a unidirectional dynamic microphone with a 14”
gooseneck. The microphone has a frequency range of 60Hz to 18kHz with
an impedance of 400ohms and a sensitivity of -47db. The stand is of heavy
diecast-zinc construction to provide stability and minimize noise caused by the
operator touching the stand.
SPECIFICATIONS
FEATURES
OVERVIEW
RM-01
Unidirectional Dynamic Microphone
14” Gooseneck
Frequency response 60Hz to 18kHz
Heavy diecast-zinc construction base
Mic On/Off Switch
Remote Chime Switch
Sensitivity -47dB ±3dB (0dB=1V/μbar@1kHz)
Impedance 400 ohms
RM-01
TYPE Dynamic Microphone
POLAR PATTERN UNIDIRECTIONAL
SENSITIVITY
(0dB=1V/Pa at 1kHz) -47 ±3dB
IMPEDANCE 400Ω
FREQUENCY RESPONSE 60Hz~18kHz
WEIGHT (SET) 1.4kg
DIMENSIONS (SET) 90(W) x 45(H) x 133(D)mm
10 20 50 100200 5001000 2000 5000 1000020000 40000
-20
-30
-40
-10
0
10
-10
-15
-20
-5
0
5
dB
FREQUENCY Hz
RESPONSEPOLAR PATTERN
1 I RM-01

Remote Microphone
 WIND SCREEN
 UNIT
This unit which range is from 60Hz to 16kHz can make
sound.
 UNIT BASE
This base settles unit, and made of aluminium ware to
protect goose neck not to be lower.
 GOOSE NECK
This goose neck can adjust the direct of unit without
moving stand.
 CONNECTOR HOLDER
This case is in order to connect stand to connector.
 3P CONNECTOR
XLR connector of stand.
 WRENCH BOLT
This screw solidifies mounting between goose neck
and connector holder.
 RUBBER FOOT
This rubber foot of stand avoid sliding on the glass or table.
 STAND
This stand made of heavy Zn diecasting which can minimize
touch noise.
 STAND COVER
 RECEPTACLE
Input signal through 3p connector of goose neck becomes
sound at this part of stand ass’y
 TALK SWITCH
After press talk switch, the microphone does work and
press again is off.
 TERMINAL BLOCK
This block is connected with remote chime. For connecting
remote chime, after open stand cover connect it with ⊖ driver.
 CHIME SWITCH
If the chime appliance is connected with the terminal
block, can produce sound.
NAME OF GOOSE NECK ASS’Y
NAME OF STAND ASS’Y
RM-01 I 2








     

Remote Microphone
After opening the cover of the stand bottom, connect the Receiver or
the Remote Chime for the system to the 2P terminal block.
Chime Ta lk
접점출력
RM-01
(Gooseneck Mic)
AOE-212N
(Audio Over Ethernet (TCP/IP))
AOE-212N
(Audio Over Ethernet (TCP/IP))
PAC-5600
(DIGITAL COMBINATION SYSTEM)
Network
ᅙÕྜྷ ┡ḡᩎ
PAM Series
(Portable Amplifier)
CHIME
RM-01
(Gooseneck Mic)
CCONNECTION FOR REMOTE CHIME
APPLICATION 1
APPLICATION 2
3 I RM-01

Remote Microphone
RM-01
• Moving Coil Dynamic Microphone
• Remote Chime Switch
• MIC On/Off Switch
• Sold separately
(MIC : MC-01 / BASE : RM-01BS)
RM-01 RMC-01
RMC-01
• Electret Condenser Microphone
• Remote Chime Switch
• MIC On/Off Switch
• Sold separately
(MIC : CMC-01 / BASE : RMC-01BS)
RM-01 RMC-01
TYPE Dynamic Mic Condenser Mic
POLAR PATTERN UNIDIRECTIONAL
SENSITIVITY
(0dB=1V/Pa at 1kHz) -47dB±3dB -47dB±3dB
IMPEDANCE 400Ω 680Ω
FREQUENCY
RESPONSE 60Hz~18kHz 100Hz ~ 16kHz
POWER - DC 1.5V
WEIGHT (SET) 1.4kg
DIMENSIONS (SET) 90(W) x 45(H) x 133(D)mm
COMPARATIVE TABLE
BLOCKDIAGRAM
RM-01 I 4

Memo

Memo

Inter-M Corp. (IMK)
719, Dobong-ro, Dobong-gu, Seoul, Korea
Overseas Sales Team
Tel_ [phone]~7 Fax_ [phone] E-mail_ [e-mail] www.inter-m.com
※Design and specication are subject to be changed for the improvement of product quality without pre notice. 2015. 6. V2