Inter-m RMC-02 User manual

Operation
Manual
RMC-02
Remote Condenser Microphone
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 2

RIS OF ELECTRIC SHOC
DO NOT OPEN

CAUTION: TO REDUCE THE RIS OF ELECTRIC SHOC .
DO NOT REMOVE COVER (OR BAC ).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

To prevent fire or shock hazard, do not expose the unit to rain or moisture.
This symbol is intended to alert the user to the presence of
uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operation and maintenance (servicing) instructions
in the literature accompanying the appliance.
Caution: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of electric shock, do not any
perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
Attentions: Pour prévenir les chocs électriques ne pas utiliser cette fiche
polarisée avec un prolongateur, une prise de courant on une
autre sortie de courant, sauf si les lames peuvent étre
insérées à fond sans en laisser aucune partie à découvert.
Warning
*WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING-WATER
AND MOISTURE: Unit should not be used near water(e.g. near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool,
etc). Care should be taken so than objects do not fall and liquids are not spilled into
the enclosure through openings.
*Do not install this equipment in a confined space such as a book case or similar unit.
*This apparatus shall not be exposed to dripping or splashing and no objects filled
with liquids, such vases, shall be placed on the apparatus.
*This apparatus shall be connected to a mains socket outlet with a protective earthing
connection.
*It has heed to be easy to disconnect the device. To disconnect the device from
power, separate AC input cable from inlet or unplug the AC Cord.
*CAUTION : These servicing instructions are for use by qualified service personnel
only. To reduce the risk of electric shock, do not perform any servicing other than
that contained in the operating instructions unless you are qualified to do so.
NOTE : This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 3

Contents
Welcome ................................................................2
Unpacking ..............................................................2
Installation
Environment.........................................................3
Important Safety Instructions ...............................3
Features...............................................................5
Constitution and Accessory.................................5
Name of Mic ........................................................6
Name of stand .....................................................7
Polar Pattern (Mic) ..............................................8
Response of frequency .......................................8
Block Diagram (Stand) ........................................9
Specifications ....................................................10
S
ervice
Procedures.........................................................11
Schematic ..........................................................11
Parts List ............................................................11
Warranty...............................................................11
1
RMC-02
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 4

2
RMC-02
Unpacking
Please take a few minutes to read this manual to
familiarize yourself with important information
regarding installation, product features, and operation.
As with most electronic devices, ORIGINAL
PAC AGING (OR EQUAL) IS REQUIRED in the
unlikely event that the product needs to be returned
for servicing.
Welcome,#-.+* (2#(!+)#/+3+0$-+)/&#) * %#)#*/
*"#),(+3##.+$*/#-
All of the co-workers here at Inter-M are dedicated
to providing excellent products with inherently
good value, and we are delighted you have
purchased one of our products.
We sincerely trust this product will provide years
of satisfactory service, but if anything is not to
your complete satisfaction, we will endeavor to
make things right.
Welcome to Inter-M, and thank you for becoming
part of our worldwide extended family!
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 5

3
RMC-02
Installation
*1'-+*)#*/
Never place this product in an environment which
could alter its performance or reduce its service life.
Such environments usually include high levels of
heat, dust, moisture, and vibration.
ImportantSafetyInstructions
1. Read these instructions.
2. eep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11. Only use attachments/accessories specified by
the manufacturer.
12. Use only with the cart, stand,
tripod, bracket, or table specified
by the manufacturer, or sold with
the apparatus. When a cart is
used, use caution when moving
S3125A
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 6

4
RMC-02
the cart/apparatus combination to avoid injury from
tip-over.
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
- AVOID EXCESSIVE HEAT, HUMIDITY, DUST AND
VIBRATION
eep the unit away from locations where it is likely to
be exposed to high temperatures or humidity-such as
near radiators, stoves, etc. Also avoid locations
which are subject to excessive dust accumulation, or
to vibration that could cause mechanical damage.
- AVOID PHYSICAL SHOC S
Strong physical shocks to the unit may cause
damage. Handle the unit with care.
- DO NOT OPEN THE CASE OR ATTEMPT REPAIRS
OR MODIFICATIONS YOURSELF
This product contains no user-serviceable parts.
Refer all maintenance to qualified Inter-M service
personnel. Opening the case and/or tampering with
internal circuitry voids the warranty.
- ALWAYS POWER OFF BEFORE MA ING CONNECTIONS
Always turn the AC mains OFF before connecting or
disconnecting cables. This is important to prevent
damage to the unit itself as well as other connected
equipment.
- HANDLE CABLES CAREFULLY
Always plug and unplug cables (including the AC
mains power cord) by gripping the connector, not the
cord.
- CLEAN WITH A SOFT DRY CLOTH
Never use solvents such as benzine or paint thinner
to clean the unit. Wipe clean with a soft, dry cloth.
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 7

5
RMC-02
Features■
■
Unidirectional electronic condenser Microphone.
■
■
Possible to use it without power supply due to using of
AA battery.
■
■
Applying of ON/OFF BUMP SOUND inhibit circuit
■
■
This stand made of heavy Zn diecasting which can
minimize touch noise.
■
■
Applying of balance output circuit for remote
installation.
Constitution and Accessory
1. Stand of RMC-02 x 1
2. Microphone of CMC-02 x 1
3. Wind Screen x 1
4. AA Battery x 2
5. Operation manual of RMC-02
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 8

6
RMC-02
Name of Stand Ass’y





 

 

 


1
2
3
4
5
6
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 11

7
RMC-02
Name of Goose neck Ass’y





 

 

 




3
4
5
7
6
2
1
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 12

8
RMC-02
Polar Pattern (Microphone)
240o
270o
300o
330o0o
30o
60o
90o
120o
150o
180o
210o
Response of Frequency
-90
-80
-70
-60
-50
-40
50k
5k500
50
dB
Hz
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 13

9
RMC-02
Block Diagram (Stand)
˅˅)58)58
1
2
3
168=<51+767..;?
1
2
3
7=<8=<4-,G,+
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 14

10
RMC-02
Specifications
* Specifications and design subject to change without notice.
Polar Pattern Unidirectional
Type electronic condenser Microphone
Sensitivity/ Impedance45dB±3dB (0dB=1V/Pa at 1kHz)
Frequency Range40Hz ~ 16kHz
Max. SPL Over 105dB
The S/N 65dB
(signal- to–noise) ratio
Output Impedance 600Ω± 30%
Gain(Base)-2dB(Battery), -1.5dB(Phantom)
Weight(set) 1.6 kg / 3.5 lB
Dimensions(set) Stand99(W) x 50(H) x 148(D)mm
3.9(W) x 2(H) x 5.8(D)in
Mic14.5(W) x 535(H) x 14.5(D)mm
0.57(W) x 21(H) x 0.57(D)in
RMC-02
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 15

11
RMC-02
Service
-+!#"0-#.
Ensure the problem is not related to operator error, or
external system devices, Once it is certain that the
problem is related to the product contact your warranty
provider as described in the warranty section of this
manual.
!&#) /'!
A Schematic is available by contacting your warranty
provider.
 -/.'./
A Parts List is available by contacting your warranty
provider.
Warranty
Warranty terms and conditions vary by country and may
not be the same for all products. Terms and conditions of
warranty for a given product may be determined first by
locating the appropriate country which the product was
purchased in, then by locating the product type.
To obtain specific warranty information and available
service locations contact Inter-M directly or the authorized
Inter-M Distributor for your specific country or region.
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 16


December 2013
Inter-M, Ltd. (Korea) began operations in 19 3.
Since then, Inter-M has grown to become one of the largest manufacturers
of professional audio and commercial sound electronics equipment in the world.
Inter-M has gained worldwide recognition for its own branded products,
as well as private label manufacturing of electronics sold under other names (OEM).
The company is no longer just a Korean company, but rather a global company
that is truly international in scope, with factories and offices in Korea and China,
and sales and marketing operations located in Japan, Europe, and the U.S.A.
With more than 50 employees around the globe,
Inter-M is well-poised for further growth and expansion.
INTER-M AMERICAS, INC.
13 75 ARTESIA BLVD. CERRITOS, CA 90703 USA
TEL : [phone], FAX : [phone]
Home Page : http://www.inter-m.net, E-mail : [email protected]
INTER-M Corporation
SEOUL OFFICE:653-5 BANGHAK-DONG, DOBONG-KU, SEOUL, KOREA
TEL : + 2-2-22 9- 140~ , FAX : + 2-2-22 9- 149
Home Page : http://www.inter-m.com, E-mail : [email protected]
RMC-02_E_PAM-MPM4_E 13. 12. 31. 오오 12:34 Page 1