Interlogix TruVision TVT-2201 User manual

TruVision IR Turret
Camera TVT
-2201/4201
Installation Guide
P/N 1072922A • REV A • ISS 10FEB15

Installation Guide 1
Contents
Package contents 2
Camera description 4
Installation 4
Specifications 8
Regulatory information 9

2 Installation Guide
Package contents
This is the TruVision IR Turret Camera Installation
Guide for models TVT-2201/4201. This guide
describes a standard installation.
The camera consists of the following:
Camera with power
and video output
cables
3 M4 screws (3 x
25 mm) and 3
drywall anchor
(Ø7.5 x 24.5 mm)
for wall or ceiling
installation
Template
Back box

Installation Guide 3
Hex wrench
Installation Guide
CD

4 Installation Guide
Camera description
1. Mounting base
2. Fixed ring
3. Lock screw
4. Enclosure
5. Camera
6. Video cable
7. Power cable
Installation
To install the camera:
1. Using the template, place it level against the
mounting surface and mark the position of the
mounting holes.

Installation Guide 5
2. Following all local codes, drill and prepare the
mounting holes.
3. Loosen the lock screw on the mounting base to
release the turret camera.
4. Securely fasten the mounting base to the
mounting surface with the screws.

6 Installation Guide
5. Connect a 75-ohm coaxial video cable to the
video cable, and connect a 12 VDC power
supply to the power cable.
6. Secure the camera to the mounting base by
tightening the lock screw.

Installation Guide 7
7. Loosen the locked screw to adjust the
surveillance angle according to the figure below,
then tighten the locked screw.
0° ~ 360°
0°
~ 75°
0°
~ 360°

8 Installation Guide
Specifications
Power supply 12 VDC
Current Max. 330 mA
Power
consumption
Max. 1.8 W (Max. 4 W with IR
cut filter on)
Weight 0.88 lb. (400 g)
Dimensions
(Ø × L)
2.76 x 5.89 in.
(89.6 x 59.1 mm)