Invacare 1085140 Assembly instructions

NOTE: Check all parts for shipping damage before
using. In case of damage, DO NOT use. Contact the
Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
safereplacementoftheFLAPKITontheReliantBath
Lift (RBL250).
GENERAL WARNINGS
DO NOT assemble or use this kit without first
reading and understanding this instruction
sheet. If you are unable to understand the
Warnings, Cautions and Instructions in this
sheet and in the Owner's Operating and
Maintenance Manual (Part No. 1081003),
provided with the Bath lift, contact a health-
care professional, dealer or technical per-
sonnel before attempting to install this kit,
otherwise, injury or damage may occur.
DESCRIPTION QTY
Flaps 2
Screws 4
Nuts - Self Locking 4
Washers 4
Hinges 4
Pins 4
Circlip 8
Instruction Sheet 1
This kit contains the following:
REPLACING THE BATH LIFT FLAPS
Removing the Bath Lift Seat (FIGURES 1-7)
NOTE: Refer to the GENERAL WARNINGS in the
SAFTY SUMMARY of this Instruction Sheet.
1. Raise the Bath Lift seat by pressing the UP (é)
buttononthependant(FIGURE1).
NOTE: The lift will automatically stop at the top and
bottom limits if UP/DOWN buttons are not released.
INSTALLATION WARNINGS
When installing or removing the Battery
pack ALWAYS hold the battery pack firmly,
otherwise injury or damage may result.
To prevent frame from tipping when rais-
ing or lowering, either suction the frame
to the floor or place one foot on the frame
base when removing/installing the seat.
FIGURE 2 - REMOVING THE BATTERY PACK
PULL UP TO
REMOVE
é
Battery Pack Frame
Handgrip
FIGURE 3 - RELEASING THE SEAT
WARNING
To prevent pinching injury between seat
back and motor shroud when removing/
installing the seat, DO NOT grasp seat
anywhere other than at the recess at
the top (FIGURE 3), the opening at the
bottom of the seat or the lip where the
battery pack was.
CAUTION
DO NOT remove the seat until the bath Lift
is raised to the upper limit. Otherwise dam-
age may occur.
3. Toreleasetheseat,pressandholdthespringloaded
chairreleasebutton (FIGURE3).
SpringLoaded
Chair Release
Button
Recess
Seat
4. While holding the spring loaded chair release button
withonehand,grasptheseatbottomfirmlywithyour
otherhand.
5. Lift the seat up until the slide block comes free of the
groovesonthebathliftframetoremovetheseatfrom
theframe(FIGURE4).
2. Remove the battery pack by grasping the handgrip
onbatterypackandpullingupwards(FIGURE2).
1
FIGURE 1 - RAISING THE BATH LIFT
Pendant
Up
Motor Shroud Battery Pack
Reliant Bath Lift (RBL250) Flap Kit
Assembly, Installation and Operating Instructions
Kit No. 1085140

2
REMOVING/INSTALLING FLAPS
(FIGURES 8 - 10)
1. Turn seat upside down.
2. Remove the two (2) self locking nuts, two (2) wash-
ers and two (2) screws that secure the hinges to the
side of the seat.
3. Remove EXISTING flapwithhinges (FIGURE8).
4. Lay NEW flap bottom side up.
5. PlaceNEWhingeintorecess in the side oftheNEW
flap(FIGURE9).
6. Insert pin through the holes in the flap and the hinge
asshown in FIGURE 9.
7. Performthefollowingproceduretoinstallone(1)circlip
oneachendofpin (DETAILA):
A. Placetheopensideofthecirclipintothegrooves
atthe ends ofthe pin.
B. Position a screwdriver at the top of the circlip.
C. Applypressuretothecirclipuntilanaudible"click"
is heard.
FIGURE 8 - REMOVING/INSTALLING FLAPS
Groove
FIGURE 4 - REMOVING THE SEAT
LIFT THE SEAT
Frame
Slide Block
6. Grasp the handgrip and slide the battery pack
onto the charger connector on the frame (FIG-
URE5).
NOTE: The battery pack should fit snugly and not
wobble.
7. Lower the bath lift by pressing the DOWN (ê)
buttononthependant(FIGURE6).
NOTE: The lift will automatically stop at the top and
bottom limits if UP/DOWN buttons are not released.
8. Remove the battery pack by grasping the handgrip
onbatterypackandpullingupwards(FIGURE7).
FIGURE 7 - REMOVING THE BATTERY PACK
PULL UP TO
REMOVE
é
Battery Pack Frame
handgrip
FIGURE 5 - INSTALLING THE BATTERY PACK
PUSH DOWN
TO INSTALL
ê
Battery Pack Frame
Handgrip
FIGURE 6 - LOWERING THE BATH LIFT
Down
Pendant
Flap Screws
Self Locking Nut
Washer
Bath Lift Seat (Bottom)
Hinges
Nut
Washer

3
8. Repeat STEPS5-7 for the remaining hinge and pin.
9. Installflapbyaligninghingemountingholewithmount-
ingholeinthesideof the seat (FIGURE 10).
10. Insertscrew throughhingemountingholeandmount-
ingholeinthesideof the seat (FIGURE 10).
11. Install washer and self locking nut on screw. Torque
to10-15in./lbs(FIGURE10).
Circlip
Hinge
Pin
Screwdriver
Circlips
FIGURE 9 - INSTALLING HINGE
DETAIL A
Flap (bottom side)
Recess
Pin
Circlip
Pin
2. Remove the battery pack by grasping the handgrip
onbatterypack andpullingupwards(FIGURE12).
FIGURE 11 - RAISING THE BATH LIFT
Pendant
Up
FIGURE 12 - REMOVING THE BATTERY PACK
PULL UP TO
REMOVE
é
Battery
Pack
Frame
Groove
Frame
FIGURE 13 - INSTALLING THE SEAT
Slide
Block Groove
Seat
LOWER
SEAT
12. Repeat STEPS 9-11 on remaining hinge.
13. RepeatSTEPS 4-12 for other flap.
REINSTALL SEAT ONTO BATH
LIFT FRAME (FIGURES 11-13)
NOTE: Refer to the GENERAL WARNINGS in the
SAFETY SUMMARY of this Instruction Sheet.
NOTE:Ifnecessary,reinstallthebatterypackontheframe.
1. RaisethebathLift all the way up by pressingthe
UP (é) button on the pendant (FIGURE 11).
NOTE: The lift will automatically stop at the top and
bottom limits if UP/DOWN buttons are not released.
FIGURE 10 - INSTALLING THE FLAP
3. Lowertheseatontotheframe,ensuringthattheslide
blockonthe backofthechairslidesdownthetwo(2)
groovesontheframe(FIGURE13).
NOTE: The seat MUST be lowered onto the frame until
the spring loaded chair release button locks in place and
an audible "click" is heard.
Flap
Screws
Bath Lift Seat
(Bottom)
Hinges
Nut Washer Hinge Mounting
Hole
Mounting Hole

PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW
APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights which
vary from state to state.
Invacare warrants the products manufactured to be free from defects in materials and
workmanship for a period of one (1) year from the date of purchase. If within such
warranty period any such product shall be proven to be defective, such product shall
be repaired or replaced, at Invacare’s option. This warranty does not include any
labor or shipping charges incurred in replacement part installation or repair of any such
product. Invacare’s sole obligation and your exclusive remedy under this warranty
shall be limited to such repair and/or replacement.
For warranty service, please contact the dealer from whom you purchased your Invac-
are product. In the event you do not receive satisfactory warranty service, please write
directly to Invacare at the address at the bottom of the page, provide dealer’s name,
address, date of purchase, and indicate nature of the defect.
Invacare Corporation will issue a serialized return authorization. The defective unit or parts
MUST be returned for warranty inspection using the serial number, when applicable as iden-
tification within 30 days of return authorization date. Do not return products to our factory
without our prior consent. C.O.D. shipments will be refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL
NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED, PRODUCTS
SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STOR-
AGE, PRODUCTS MODIFIED WITHOUT INVACARE’S EXPRESS WRITTEN CONSENT (INCLUDING,
BUT NOT LIMITED TO, MODIFICATION THROUGH THE USE OF UNAUTHORIZED PARTS OR AT-
TACHMENTS; PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT
WITHOUT THE SPECIFIC CONSENT OF INVACARE, OR TO A PRODUCT DAMAGED BY CIRCUM-
STANCES BEYOND INVACARE’S CONTROL, AND SUCH EVALUATION WILL BE SOLELY DETER-
MINED BY INVACARE. THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NOR-
MAL WEAR OR FAILURE TO ADHERE TO THE INSTRUCTIONS IN THIS MANUAL.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
IMPLIED WARRANTIES, IF ANY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, SHALL NOT EXTEND BEYOND THE DURATION OF THE
EXPRESSED WARRANTY PROVIDED HEREIN AND THE REMEDY FOR VIOLATIONS OF ANY IM-
PLIED WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PROD-
UCT PURSUANT TO THE TERMS CONTAINED HEREIN. INVACARE SHALL NOT BE LIABLE FOR ANY
CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.
SOME STATES DO NOT ALLOW EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUEN-
TIAL DAMAGE, OR LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE
EXCLUSIONS AND LIMITATIONS MAY NOT APPLY TO YOU.
THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE OR PROVINCIAL LAWS AND
REQUIREMENTS.
LIMITED WARRANTY
Invacare Corporation www.invacare.com
USA
One InvacareWay Invacare is a registered trademark of Invacare Corporation.
Elyria, Ohio USA ©
1999 Invacare Corporation
44036-2125
800-333-6900 Form No. 98-327 Part No. 1085313 RevA (1)-1/00