iOptron iPolar 3339R-SGP User manual

iPolarInstallation–SkyGuiderPro(#3339R‐SGP)
Toolneeded:2mmand2.5mmhexkeywrench
1. Loosentwoscrewsatthefrontofthemountand
two others on the top of a SkyGuider Pro main
boardcoverandremovetheblackcover.

2. Unplugthe6‐wiremotordrivercableandDCpower
cable.Rememberhowwireswrapped.

3. Removetwomountingscrews.

4. Gently pull the circuit board with sockets end up
andslidethecircuitboardout.

5. DisconnectthepolarscopeLEDcable.

6. RotatetheRAaxistofindtwosetscrewsnexttothe
LED board, which are used to secure the polar
scope in place. Use a hex key to release the set
screws.PullthepolarscopeoutoftheRAaxle.

7. Removepolarscopecoverandbase.

8. RemovethepolarscopeoutoftheRAaxis.

9. InserttheiPolarintotheRAaxis.Lockthesetscrew
gentlytosecuretheiPolar.

10. ReplacethePolarScopebaseplatewithanewone
withlargeropening.
Wirewrapping


11. YoucanremovetheLEDboardandcablesinceitis
not needed for iPolar. Sliding the front end of the
controlboardin.

12. Gently push the board in when the power cable
goesthroughthesmallcutontheboard.

13. When securing the board with two screws, make
sure that the battery and wires underneath are
properlyseated.Fullytightenthescrews.
14. Putthecoverandscrewson.Refertostep2to
wrapthewireprperly.
15. Ifyouhavedifficulttoremovetheboardfromthe
mount,youmayremovethemotorfromthemotor
assembly to have more accessing spaces. Contact
iOptronsupportteamforaninstruction.
16. FollowiPolarOperationManualtoperformthe
polar alignment. You may slightly release the RA
clutch disk to rotating the SkyGuider Pro RA axis
during3‐pointcameracentercalibration.