PLDC01986
DAILY MAINTENANCE
Empty the dirty water tank.
Clean the dirty water tank.
Check the detergent output filter
is undamaged and clean.
Check the dirty water tank float is
undamaged and clean and
moves freely on the pin.
Clean the brush.
Check the squeegee is clean and
the blades are not damaged.
Check the battery charge
(BATTERY VERSION)
To recharge the batteries, plug in
the battery charger (OPTIONAL)
using the extension provided with
the machine.
REPLACING THE SQUEEGEE BLADES
•unscrew the nuts fixing the blade retainers;
•remove the two blade retainers;
•remove the blade;
•put the same blade back, reversing the edge in contact with the floor until all four edges are worn, or replace with a new one;
•put the two blade retainers back on the squeegee and screw up the nuts again;
AUTOMATIC BRUSH ATTACHMENT
Attaching the brush: rest the brush on the floor in front of the machine. Raise the front of the machine by levering on the handle, then lower it onto
the brush, centring it with the brush cover. Action the drive lever repeatedly until the brush engages.
Removing the brush: Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly. After operating the lever a
few times, the brush is released and falls to the ground.
TROUBLESHOOTING
THE MACHINE DOES NOT COME ON/START UP CHECK THE BATTERY CHARGE (BATTERY VERSION)
CHECK THE POWER CABLE IS PLUGGED INTO A FUNCTIONING SOCKET (CABLE
VERSION)
THE MACHINE LEAVES THE FLOOR WET
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE
CHECK THE DIRTY WATER TANK IS NOT FULL
CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY
CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE
THE MACHINE LEAVES THE FLOOR DIRTY CHECK THE TYPE OF BRUSH IN USE IS SUITABLE FOR THE TYPE OF DIRT AND
FLOOR.
THE MACHINE LEAVES STRIPES OF WET FLOOR
CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED
