Step 1. Press the F (function) button and the rst character will ash. Press the S (setting) button to change the
value.
Step 2. Move to the next character press the F button again. Use the S button to change the value.
Step 3. Pressing the F button again when the last character is ashing will make the whole display ash for about 5
seconds to indicate the settings have been saved.
Step 4. Now press the RST (reset) button for 1 second on each IPmitter. The display will change to a P with a rotating
segment whilst pairing and will show a value when paired.
Pairing can take up to 2 1/2 minutes.
To add more clients (up to 4) to one host then set the channel on the new client and press the reset buttons
on the new client and the ost. They will then pair.
Scan the QR Code for the Full Setup Manual
Trouble shooting
Q.1 Why is the Signal strength of P-095?
A.1 1. Check the pairing > The signal strength of P-095 shows they have not paired up correctly. Reset both
IPmitters, holding the R (reset) button down on both IPmitters for 10 seconds. Once both units have booted
back up, then try the pairing process again.
2. Between P-070 and P-095 is too low for transmission > Try the pairing process with the devices closer
together.
Q.2 Why is my IPmitter not pairing?
A.2 1. Check the signal strength on the LED display at the ost and Client IPmitter.
2. Check the SYS light at the ost and Client IPmitter > If the SYS light is not lit then check your 48V PoE
source or 12V DC source.
3. Check the WAN or LAN indicator ost and Client IPmitter > This will light up if a device connected and
powered correctly. Please note this may not just be a power issue for the device connected but the cable
connecting the IPmitter and the devices may be wired incorrectly or the cable may have a fault.
All specications are approximate. IPmitter.com reserves the right to change any product specication or features without
notice. Whilst every eort is made to ensure that these instructions are complete and accurate IPmitter.com cannot be held
responsible in any way for any losses no matter how they arise from errors or omissions in these instructions or the
performance or non-performance of the camera or other equipment that these instructions refer to.
IPmitter.com April 2020 – v1.0 2
