IVIGO EFP4550E25 User manual

ELECTRIC
HEATER WITH FAN
since
USER MANUAL
Model:
EFP4550E25
EFP4550M25
Manual
Digital
UPDATED
Vigo brand changed to Ivigo from March 2019.

2
ENVIRONMENTAL POLICY
We hereby commit that we are going to:








        





3
EN
Our Esteemed Customer,















            


4
SAFETY INSTRUCTIONS
Digital Electric Fan Heater is switched on for the rst time, the fan will blow
cold air for approximately 15 sec. This is to prevent the possible dust on the resistor from
burning.The resistor will start working after 15 sec. and the device will blow hot air.

without the fan function.
Digital Electric Fan Heater is a special cable with a heat sensor. It
senses if there is any heating in the socket and switches o the device. In such case, the
temperature of the socket must cool down before the device can operate again. Unplug
the device and allow the plug to cool down, if necessary, use a dierent outlet. (Our patent
for 2013/12486 plug with heat sensor is in the process of formal inspection by the Turkish
Patent Institution.)

to the“0”position while the unit is operational may damage the product. Be careful not to
switch it o in such a manner. The unit should be unplugged or the power switch should
be turned o after the unit is turned o using the on/o switch on the control panel or the
remote control.

be covered.

with the AlternativeVoltage (AC) and sucient current rated power outlets.

responsible for the damages caused due to use without the application of grounding.

carefully.

5
EN


use your heater. Please refer to the dealer with warranty card and bill.


before cleaning.


use.

place cloth thereon.

stored.



create an electric shock hazard.

not unplug by pulling on cord.
              
operating any switch on the product or touching the plug.
            
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person

6
responsible for their safety.

timers or programmers.

cause an electric shock or re damage to the appliance.

combustible materials at least 1.0 m away from the heater.




outlet.(receptacle)

Always switch o and let cool down before moving.




panel should be cleaned with a vacuum cleaner regularly (twice a year).



network cable of your electric heater. Do not operate your heater.

7
EN
TABLE OF CONTENTS
1. GENERAL OVERVIEW AND TECHNICAL FEATURES 8
2. INSTALLATION INSTRUCTIONS 12
3. OPERATING INSTRUCTIONS 15
4. CLEANUP and MAINTENANCE 18
5. TRANSPORTATION INFO 18
6. PRACTICAL AND USEFUL INFORMATIONS 18
7. GUARANTEE CONDITION 19





8
Manual Electric Heater With Fan
   
 
    
      

      









EFP MANUAL SAFETY SYSTEMS





      
    
     
    
      
      
       

   
      
 




7





1. GENERAL OVERVIEW AND TECHNICAL FEATURES

9
EN
Electric Heater With Fan Model Selection
Model Recommended Heater Power (watt) Room Area (m2)
EFP 4550 E25/M25 2500 
The heat requirement depends on factors such as the exterior temperature, room
heat isolation, door open/close cycles. The values stated on the above table are for
average conditions with an outside temperature of 8-10 degrees therefore when
calculating the heater power these factors should be taken into consideration.
TECHNICAL SPECIFICATIONS
Circuit Diagram for ManualElectric Heater WithFan













Manual Electric Heater With Fan
Type EFP4550EM5
Height mm 450
Length mm 500
Depth mm 98
         7
 
Voltage V 
Current A 10.9
 
Electronic Room Temperature Control 
Energy Saving Module 
On / O Switch 
Cord Length m 2
ProtectionType I
 IP 24
Thermostat Against Excessive Heat Disponible
Mechanical Thermostat Control Disponible
Energy Consumption Display 
Room Temperature Display 
Fan Disponible
Sound Level dB max.50
Color Choices 

10
Digital Electric Heater With Fan
   
 
    
      

      










* The Electric Fan Heater’s plug cable is a
special cable with a heat sensor and it senses
when the socket is warm and cuts the power.
EFP SAFETY SYSTEMS


   





      
    
     
    
      
      
       

   
      
 




8


7




11
EN
Electric Heater With Fan Model Selection
Model Recommended Heater Power (watt) Room Area (m2)
EFP 4550 E25/M25 2500 
Outdoor temperature is 8-10 degrees. The heat requirement depends on factors such
as the exterior temperature, room heat isolation, door open / close cycles. The values
stated on the above table are for average conditions therefore when calculating the
heater power these factors should be taken into consideration.
Digital Electric Heater With Fan
Type EFP4550E25
Height mm 450
Length mm 500
Depth mm 98
             7.8
 
Voltage V 
Current A 10.9
 
Electronic Room Temperature Control Disponible
Energy Saving Module
(Programmable)
Disponible
On / O Switch Disponible
Cord Length m 2
ProtectionType I
 IP 24
Thermostat Against Excessive Heat Disponible
Mechanical Thermostat Control 
Energy Consumption Display Disponible
Room Temperature Display Disponible
Fan Disponible
Sound Level dB max.50
Color Choices 
 Disponible













TECHNICAL SPECIFICATIONS






12





Screw


  
 







o
o
o


o

 
Wall Mounting
1. Open the packing box and take out the heater with its protective nylon cover. Tear the protective
nylon cover outside the box without giving any harm to the appliance and take out the hangers
attached on the unit by pulling the springs thereon.
2. Correct space has to be measured n order that the connecton cord can easly be connected to
the electrc socket. After determnng the place the holes for montage must be drlled accordng to
the method shown n Fgure 7. To fx ths applance you can use the wall mountng bracket. (Fgure




work ecently. (Figure 6.)
3. After marking the points, the holes will be drilled by a Ø9 mm drill and the plastic dowels that
are in the montage items are driven to these holes.


as demanded.
2. INSTALLATION INSTRUCTIONS

13
EN
      

     

      
    
      



    
      














heater



14
Use Of Heater With Legs


  






 
e
e
e
e







15
EN
Manual Electric Heater With Fan


 


Switching on the Unit




Increasing and Decreasing Temperature




Switching o the Device
             

3. OPERATING INSTRUCTIONS

16
Digital Electric Heater With Fan














Switching on the Unit
Put the plug in a grounded socket to operate your appliance. Bring the power switch (Figure l.) ON position
 ) button of your appliance for a short while. The

Increasing or reducing the temperature

left sides of the On/O button. If you want to increase or reduce the temperature push the relevant button
(for increasing ( ) button and for decreasing ( 





Programming the Timer / Turn on timer


operate before you come home. In this case the plug must be placed in the socket and the power switch (See
 ) to
without pushing the On/O button ( 

warning light will appear on the indicator display and will shine until the appliance starts to operate. The unit
will run automatically on the set time automatically and will start heating. If you want to reset the timer you
have to push the button ( ) to on position and then o again.

17
EN
Turn o timer
Turn o timer is a function for turning o the appliance automatically when the appliance is working. Turn o
 

will appear on the indicator display and will shine until the appliance starts to operate. This light will be on
until the appliance is o and the appliance will close automatically on the set time (hour) seen on the indicator
display. If you want to reset the timer you have to push the button ( ) to o position and then on again.
Safety lock
If you keep pressing the turn on safety button ( 


the turn on safety button ( 
appear on the screen. After appearance of this word the buttons will be ready for general use.
Turning o the Appliance

pushing to power switch.
Note: The timer will keep the turn on timer or turn o timer program in its memory during a power
failure and when power is restored it will run the program and keep working in normal conditions. If you
want to reset the timer you have to turn o the power switch of the appliance.
Remote Control (Standard)



    



18
5. TRANSPORTATION INFO

            





  
            
    



6. PRACTICAL AND USEFUL INFORMATIONS

          
  
 

Note: 

4. CLEANUP and MAINTENANCE

19
EN





            







        

            



     

                


THINGS TO DO BEFORE CALLING THE DEALER:

 












7. GUARANTEE CONDITION

20
WARNING CODES
Digştal Electric Fan Heater
Warning Code Description Action
L
LDR calibration menu (This
warning appears when enter
ing the light calibration menu)
It is for you to make sure that you are in the
correct menu.
A
NTC calibration menu (This
warning appears when enter
ing the ambient temperature
calibration menu)
It is for you to make sure that you are in the
correct menu.
PE
Overheating warning for the
plug (This warning is activated
when the plug temperature
exceeds 80 degrees)
Immediately unplug the device and allow it

used again, but it is necessary not to use it in
the socket where the overheating occurred and

and replace the plug if necessary.
F1
Fan block warning. (This warn
ing is displayed if the outlet
NTC exceeds 150 degrees)
Immediately unplug the device and remove
any obstructions blocking the front or back
of the device.The device can be used again

same warning is displayed even though the
obstacles have been removed, the technical
service should be contacted.
F2
Fan malfunction warning.
(This warning is displayed
if the outlet NTC exceeds 70
degrees and the ambient NTC
exceeds 50 degrees)
The device must be unplugged immediately
and the issue should be reported to the techni
cal service.