Jabra Engage 65 Mono User manual

How do I use the conference call mode with my Jabra Engage
65?
Jabra Engage 65 Mono
You can set up a conference call with the Jabra Engage 65 by pairing up to
three additional headsets with the same base. You can pair a headset
“over the air” or dock it in the base. If you dock a headset in the base, the
headset must have the same docking interface as the base. For example, a
Jabra Engage mono headset and a Jabra Engage mono or stereo base.
1. Add headset(s) using base docking
1. Undock the primary headset.
2. Dock an additional headset in the base.
3. When the headset has been successfully paired with the base, a voice
prompt is announced in the primary headset. Press the Call button on
the primary headset to accept the additional headset. The audio is then
shared with additional headsets, which are muted by default.
2. Add headset(s) without base docking (pair over the air)
06/04/2021 20:43
/supportpages/jabra-engage-65/9553-553-117/faq/fc22e06a-4783-42e4-9446-
47c7b06676ea
Page 1 of 2

1. Undock the primary headset.
2. Turn off the additional headset by holding the Call button for 4
seconds.
3. Hold the (3 seconds) on the base. The conference LED will flash.
4. Put the additional headset into pairing mode by holding the Call button
for 5 seconds until the LED on the headset flashes blue. The base and
the headset will attempt to pair.
5. Press the Call button on the primary headset to accept the additional
headset and complete the pairing. The audio is then shared between
headsets, which are muted by default.
End or leave a conference call
To end the call for all headsets, press the Call button on the primary
headset, or dock the primary headset in the base. Additional headsets can
leave the conference by pressing the Call button on the headset or by
docking the additional headset in the primary headset base (not the
additional headset base). The conference call will continue for all other
headsets.
Permanent conference mode
By default, the conference will end automatically for all additional
headsets when the call ends. To continue the conference with the
additional headsets until the primary headset is docked, change this
specific setting in Jabra Direct.
06/04/2021 20:43
/supportpages/jabra-engage-65/9553-553-117/faq/fc22e06a-4783-42e4-9446-
47c7b06676ea
Page 2 of 2