Jack Richeson Aztec 886001 Administrator Guide

HOW TO ASSEMBLE THE
Aztec Easel
#886001 Made from Lyptus® Wood
Lyptus®is a registered trademark of Weyerhaueser.
Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: [phone] - www.richesonart.com 3/08
Assembly instructions for the Aztec Easel.
A. Easel Base & Frame
B. Bottom Canvas Holder
Parts Bag Contains:
4 - 11/2" Self Leveling Feet
2 - 13/8" Wood Screws
Parts Bag
Step One:
Lift the Frame of the Easel to a vertical position
and tighten the Slide Guide System that holds
the Support Legs in place.
Step One
Slide Guide System

Step Two:
Attach the Bottom Canvas Holder to the
Adjustable Mast with the 13/8" Wood Screws.
Note: For permanent stability apply wood glue
to the dowels before attaching the Bottom Canvas Holder.
Adjustable Mast
Step Three:
Tip Easel over to screw
the Self Leveling Feet to the
four corners of the Easel Base.
Adjust as needed to the level
of your home or studio.
Knobs to adjust the
Mast and Top Canvas
Holder height.