Jack Richeson LOBO Administrator Guide

HOW TO ASSEMBLE THE
Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: [phone] - www.richesonart.com 7/13
A. Easel
Frame
With Mast
1. 2 - Slide Guides
2. 2 - Knobs (with bolt)
3. 2 - Plastic Washers
4. 3 - Wood Screws
5. 2 - Brass Washers
6. 1 - Knob
7. 1 - Bolt
8. 1 - Slide Guide
9. 1 - L-Bracket
10. 2 - Wood Screws
11. 1 - Knob (with bolt)
Step One:
Attach the Easel
Frame (A) to the
Base (C), with the
hardware in Parts Bag 1.
Thread the Knob (with
bolt) through the Plastic
and Brass Washers, the
Base leg, the Slide Guide,
and into a recessed nut
on the Easel Frame.
Tighten. Repeat on
other side.
C. Base With
Shelf
B. Back
Support
Leg
1 2
3 4 5
Parts Bag 1
Parts Bag 2 Parts Bag 3
6
7
8
9
10
11
Step 1
Step Two:
Using the 3 screws from Parts Bag 1, mount the hinge on
the Back Support Leg (B) using the pre-drilled holes on the
back of the Base (C).
Step Two
You may select any of the 5 height
positions for your easel frame.
Pre-drilled
hinge holes
for Step 2.
Lobo Easel
#883201 Made from Lyptus ® Wood
Lyptus® is a registered trademark of Weyerhaueser.

Step Three
Step Four:
In Parts Bag 3, there is an L-Bracket that can be attached to
the back of the adjustable Mast to hold the Mast up when
no canvas is in place. Mount with the 2 Wood Screws into
the pre-drilled holes.
Step Four
Step Five:
To adjust the height of the adjustable Mast, insert the Knob
with bolt (11) from Parts Bag 3. Tighten at desired height.
Step Five
Step Three:
In Parts Bag 2 you will find the
Slide Guide System to join the
hinged Support Legs together.
Thread the Bolt through both
legs, the Slide Guide and into the
Knob. Tighten at desired angle.
Inside of Easel
Outside of
Easel Support
Leg