Jack Richeson Lyptus 844200 Administrator Guide

HOW TO ASSEMBLE THE
Table Top Easel
#844200 Made from Lyptus® Wood
Lyptus®is a registered trademark of Weyerhaueser.
Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: [phone] - www.richesonart.com 4/08
Jack Richeson & Co., Inc. P.O. Box 160, Kimberly, WI 54136-0160 1-800-233-2404 Fax:[phone] richesonart.com
Assembly instructions for the Table Top Easel.
A. Easel Base With Support Legs B. Frame With Mast
C. Bottom
Canvas
Holder
D. Parts Bag
1
Parts Bag Contains:
1. 2 - 13/8"Black Knobs
2. 2 - Slide Guides
3. 2 - 23/8" Bolts
4. 17/8"Black Knob With Bolt
5. 4 - 5/8"Wood Screws
2
3 4
5
Parts Bag
Step One:
Attach the Frame (B) to the Easel Base (A)
using the Wood Screws (5). Line up the
brass hinges to the pre-drilled holes on
the bottom edge of the Frame and insert
screws. Tighten with a screw driver.
Step One

Step Two:
The Support Legs connect to the Frame (B) with the use of Slide Guides.
Thread the 23/8" Bolt through the hole in the Support Leg, through the slotted
area in the side of the Frame, and through the Slide Guide.
Use the 13/8"Black Knob to tighten into position.
Repeat on other side.
Step Three:
Loosen the black knob on the Bottom Canvas Holder (C) and slide over the Mast.
Position at desired height and tighten the knob.
Step Four:
Remove the Top Canvas Holder from the Mast and turn it around to face the
front of the easel. To set into place insert the 17/8"Black Knob With Bolt into the
hole on the back of the Frame. Tighten when the Top Canvas Holder is at the
height you want.
Top Canvas Holder Bottom Canvas Holder
Step Two
Step Three
Step Four