Jacob Jensen Electronic Parking Disc 3 User manual

Product by
Bent Neubauer Holding ApS
Droshoved 9, 7120 Vejle Ø
Denmark
www.jacobjensen.com
Electronic Parking Disc 3
Quick guide
Electronic Parking Disc 3
Start here

JACOB JENSEN
JACOB JENSEN
JACOB JENSEN
4. Clean the window with the included
alcohol wipe. Avoid using window
cleaners as they may contain waxes
or oils.
5. Carefully remove the protective
lm from the adhesive pads on the
front plate. You can use a thin blade
for help. The adhesive pads adhere
best at temperatures above 10°C.
6. Install in the lower right corner of
the windscreen. The parking disc
must visible from the outside without
problems. Press lightly to remove any
air bubbles under the adhesive pads.
7.When the car is parked, the parking
disc will automatically switch to park-
ing mode and the blue LED will ash.
8. When the ‘P’ icon is displayed, the
parking function is active. The parking
time is set automatically. The parking
time, can be adjusted manually by
pressing and for 2 sec.
9. When the car starts to drive, the
display automatically switches back
to clock mode. After 15 sec. the display
turns off to save power.
3.Press SET. Set country, year, month,
date and time using the / buttons
above the display and confirm each
selection with the SET button.
When resetting, press SET until ‘DK’
ashes in the display.
1. Adjust country with or .
2. Press SET to shift to year (‘Y’).
Set year with or .
4. Press SET to shift to month (‘M’).
Set with or .
5. Press SET to shift to day (‘D’).
Set with or .
6. Press SET to switch to timer.
Set with or .
6. Press SET to shift to minutes.
Set with or .
7. Press SET to exit. The parking disc is now
set and ready for mounting.
Full user manual can be downloaded at
jacobjensen.com/automotive
1. Open the battery cover and remove
the plastic strip to activate the P-disc.
The LCD display now shows year.
2. Lift off the front plate so that the
buttons are visible.