www.jakohardware.com
INSTALL EXTERIOR MECHANISM
6
For right doors, take the outer cylinder with the platen
(knob) facing you and turn it clockwise (right) until it stops
and is horizontal. Then insert it through the slot in the latch.
For left door, take the cylinder in the same direction, but turn
the plate counterclockwise (left).
INSTALL THE RECEIVER
8ADJUSTABLE LATCH INSTRUCTIONS
9
Close the door and with the help of the latch mark its
position in the door frame.
Mark the center of the 25mm hole and the location of
the screws. Make a 3mm deep box and then drill the
25mm hole. Then place the receiver and tighten.
Hold the frontal and with the other hand turn the lock
case 1/4 of turn, then retract or pull it according to the
case until the pin is located again.
INSTALL THE LATCH
7
For a single cylinder.
Insert the screws and secure them.
For double cylinder
Position the cylinder platen (knob) vertically and insert
it through the slot in the latch. Insert the screws and
secure them
1 2
INSTALLATION PATTERN
BEND HERE
OVER THE
EDGE OF THE
DOOR.
MARK THE CENTER
OF THE DOOR
EDGE.
54mm
2-1/8”
60mm.
70mm.
Doorknob slot
Cylinder platen (control).
For a single cylinder For double cylinder
Receiver
Door edge line.
Frontal
Case
70mm (2-3/4”)
60mm (2-3/8”)
Pin
