JASON Hydrotherapy MicroSilk User manual

Jason International, Inc. • 501.771.4477 Page 1 of 2 Customer Service : 800.255.5766
Copyright © 2014 Jason International.
“TO BE REMOVED FOR USE BY THE OCCUPANT.”
49-2005-001
Date 11/14
OWNER’S MANUAL
MicroSilk®Shower Wand and Hose Assembly (Generation 2)
OPERATION AND MAINTENANCE
INTRODUCTION
Jason’s MicroSilk Wand is designed as an accessory to your
MicroSilk Bath and provides all the benefits of MicroSilk to
the bather’s face, scalp and upper body. Simply plug Wand
into the bath’s MicroSilk port before turning on the system.
After port is securely plugged, direct Wand as desired and
turn on the system to begin flow.
Included with each MicroSilk Shower Wand and Hose
Assembly:
• One (1) MicroSilk Shower Wand
• One (1) 63” Shower Hose
• One (1) Shower Wand Adapter
• Two (2) Hose Gasket Washers
INSPECTION
Inspect the kit for damage and any shortages prior to
installation. Damage sustained in transit is the responsibility
of the carrier. If transit damage is discovered, notify the
carrier immediately and file a freight claim with them. If any
shortages are noted, contact Jason Customer Service at
800-255-5766.
OPERATION
1) Locate the MicroSilk Shower Wand Adapter.
See Figure 1.
2) Before turning on the system, connect the Shower
Wand Adapter into the port. Position the adapter
with the flow relief holes in the downward direction.
See Figure 2.
3) After wand is securely plugged in, direct the MicroSilk
Shower Wand as desired and turn on the system
to begin flow.
4) After use, turn off the system and disconnect the Shower
Wand Adapter from the MicroSilk port.
NOTE: The MicroSilk Shower Wand should be disconnected
after each use to ensure that the MicroSilk system drains
properly. The Shower Wand should be drained and stored
in a safe location.
Figure 1
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
MADE IN THE U.S.A.

Jason International, Inc. • 501.771.4477 Page 2 of 2 Customer Service : 800.255.5766
Copyright © 2014 Jason International.
CLEANING
In order to maintain the high quality finish of the product
you have purchased, please adhere to the following product
care instructions.
For routine cleaning, simply use a soft damp cloth and
common household soap, then rinse and dry. Proper care
of your product is important because most water contains
calcium that deposits on surfaces, forming undesired spots.
This can be avoided by routine cleaning and drying after
every use. Use only mild soap-based detergents. Never
use abrasive cleaners, bleach, disinfectants or cleaning
products containing alcohol, ammonia, hydrochloric or
phosphoric acids as they will damage the product finish.
Over time, calcium may build up in the nibs and diminish the
performance of your shower product. Rubbing your fingers
over the nibs occasionally while operating your shower
product will clear the calcium build up.
Please note: Your product warranty may not be valid if the
above cleaning guidelines are not followed.
Figure 2