JDS Uniphase IP Video Test Option HST-3000 User manual

HST-3000
ADSL2 Testing
User’s Guide

Communications Test and Measurement Solutions
One Milestone Center Court
Germantown, Maryland 20876-7100 USA
Toll Free 1-855-ASK-JDSU
Tel [phone]
Fax [phone]
www.jdsu.com
HST-3000
ADSL2 Testing
User’s Guide

ii HST-3000 ADSL2 Testing User’s Guide
Notice Every effort was made to ensure that the information in this
document was accurate at the time of printing. However, infor-
mation is subject to change without notice, and JDSU
reserves the right to provide an addendum to this document
with information not available at the time that this document
was created.
Copyright © Copyright 2012 JDS Uniphase Corporation. All rights
reserved. JDSU, Communications Test and Measurement
Solutions, and the JDSU logo are trademarks of
JDS Uniphase Corporation (“JDS Uniphase”). All other trade-
marks and registered trademarks are the property of their
respective owners. No part of this guide may be reproduced
or transmitted electronically or otherwise without written per-
mission of the publisher.
Copyright release Reproduction and distribution of this guide is authorized for
Government purposes only.
Trademarks JDS Uniphase, JDSU, HST-3000, and HST-3000C are trade-
marks or registered trademarks of JDS Uniphase Corporation
in the United States and/or other countries.
Dr. DSL is either a trademark or registered trademark of
Aware, Inc. in the United States and/or other countries.
Infineon is either a trademark or registered trademark of Infi-
neon Technologies AG in the United States and/or other coun-
tries.
Conexant is either a trademark or registered trademark of
Conexant Systems, Inc. in the United States and/or other
countries.
Broadcom is either a trademark or registered trademark of
Broadcom Corporation in the United States and/or other coun-
tries.

HST-3000 ADSL2 Testing User’s Guide iii
Specifications, terms, and conditions are subject to change
without notice. All trademarks and registered trademarks are
the property of their respective companies.
Ordering
information
This guide is a product of JDSU’s Technical Information
Development Department, issued as part of the HST-3000.
The catalog number for a printed guide is ML-059701. The
catalog number for a USB stick containing the manual in elec-
tronic form is ML-060301.
Terms and
Conditions
The provision of hardware, services and/or software are sub-
ject to JDSU’s standard terms and conditions available at
www.jdsu.com.
Federal
Communications
Commission (FCC)
Notice
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.

iv HST-3000 ADSL2 Testing User’s Guide
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
In order to maintain compliance with the limits of a Class B
digital device JDSU requires that quality interface cables be
used when connecting to this equipment. Any changes or
modifications not expressly approved by JDSU could void the
user's authority to operate the equipment.
Industry Canada
Requirements
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
WEEE and Battery
Directive
Compliance
JDSU has established processes in compliance with the
Waste Electrical and Electronic Equipment (WEEE) Directive,
2002/96/EC, and the Battery Directive, 2006/66/EC.
This product, and the batteries used to power the product,
should not be disposed of as unsorted municipal waste and
should be collected separately and disposed of according to
your national regulations. In the European Union, all equip-
ment and batteries purchased from JDSU after 2005-08-13
can be returned for disposal at the end of its useful life. JDSU
willensurethatallwasteequipmentandbatteriesreturnedare
reused,recycled,ordisposedofin anenvironmentally friendly
manner, and in compliance with all applicable national and
international waste legislation.
It is the responsibility of the equipment owner to return equip-
ment and batteries to JDSU for appropriate disposal. If the
equipment or battery was imported by a reseller whose name
or logo is marked on the equipment or battery, then the owner
should return the equipment or battery directly to the reseller.

HST-3000 ADSL2 Testing User’s Guide v
Instructions for returning waste equipment and batteries to
JDSU can be found in the Environmental section of JDSU’s
web site at www.jdsu.com. If you have questions concerning
disposal of your equipment or batteries, contact JDSU’s
WEEE Program Management team at
[email protected].

vi HST-3000 ADSL2 Testing User’s Guide

HST-3000 ADSL2 Testing User’s Guide vii
Contents
About This Guide xi
Purpose and scope . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .xii
Assumptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .xii
Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .xii
HST-3000 ADSL2 Testing User’s Guide. . . . . . . . . . . . . xiii
HST-3000 Base Unit User’s Guide . . . . . . . . . . . . . . . . . xiii
Safety and compliance information. . . . . . . . . . . . . . . . xiii
Technical assistance. . . . . . . . . . . . . . . . . . . . . . . . . . . . xiv
Conventions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .xv
Chapter 1 Getting Started 1
About ADSL2 testing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Quick tour. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
User interface navigation . . . . . . . . . . . . . . . . . . . . . . . 6
Sealing current terminator. . . . . . . . . . . . . . . . . . . . . . . 6
Updating the modem software . . . . . . . . . . . . . . . . . . . 7

Contents
viii HST-3000 ADSL2 Testing User’s Guide
Chapter 2 ADSL2 Testing 9
Accessing the ADSL2 testing feature. . . . . . . . . . . . . . .10
Testing in modem emulate mode . . . . . . . . . . . . . . . . . . 11
Specifying test settings. . . . . . . . . . . . . . . . . . . . . . . . . 12
Connecting to the line . . . . . . . . . . . . . . . . . . . . . . . . . 16
Testing the physical layer. . . . . . . . . . . . . . . . . . . . . . .17
Testing line quality . . . . . . . . . . . . . . . . . . . . . . . . . . . .18
Running a Dr. DSL test . . . . . . . . . . . . . . . . . . . . . . . .19
Testing in ADSL ATU-C mode . . . . . . . . . . . . . . . . . . . . . 21
Specifying test settings. . . . . . . . . . . . . . . . . . . . . . . . . 21
Specifying general modem settings. . . . . . . . . . . . 21
Connecting to the line . . . . . . . . . . . . . . . . . . . . . . . . . 22
Testing line quality . . . . . . . . . . . . . . . . . . . . . . . . . . . .23
Testing Data services. . . . . . . . . . . . . . . . . . . . . . . . . . . .24
Specifying the emulation type . . . . . . . . . . . . . . . . . . . 24
Specifying test settings. . . . . . . . . . . . . . . . . . . . . . . . . 25
Specifying data settings. . . . . . . . . . . . . . . . . . . . . 26
Specifying LAN settings. . . . . . . . . . . . . . . . . . . . . 28
Specifying WAN settings . . . . . . . . . . . . . . . . . . . . 30
Specifying 802.1x security settings . . . . . . . . . . . .32
Specifying STUN settings . . . . . . . . . . . . . . . . . . . 33
Specifying PPP settings. . . . . . . . . . . . . . . . . . . . .34
Specifying ping settings. . . . . . . . . . . . . . . . . . . . .35
Specifying trace route settings. . . . . . . . . . . . . . . . 36
Specifying FTP/HTTP settings. . . . . . . . . . . . . . . . 37
Specifying ATM BERT settings . . . . . . . . . . . . . . . 39
Connecting to the line . . . . . . . . . . . . . . . . . . . . . . . . . 40
Testing line quality . . . . . . . . . . . . . . . . . . . . . . . . . . . .41
Performing a ping test . . . . . . . . . . . . . . . . . . . . . . . . . 42
Releasing IP addresses. . . . . . . . . . . . . . . . . . . . . . . . 43
Throughput testing. . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
ATM BERT testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
Measuring throughput using JDSU QoS . . . . . . . . . . . 45
Step 1: specifying test settings . . . . . . . . . . . . . . . 46
Step 2: measuring throughput . . . . . . . . . . . . . . . . 48