Jensen MWR75 User manual

Figure A
Introduction
Thank you for choosing a Jensen product. The MWR75 Marine Wired Remote Control allows you to control
basic functions of Jensen Marine radios, including power, mode, volume, tuning, CD, CD changer and
satellite tuners.
Installation
1. Choose a mounting location on the instrument panel that will allow enough room behind the panel to run
the wired remote cables to the existing radio.
2. Cut a hole in the instrument panel using the supplied template. At least 2 ½" depth is needed to mount
the remote control.
Important: Do not mount unit where it can be submerged or subjected to high pressure spray.
3. Insert the remote control into the rubber foam gasket and then into the hole in the instrument panel.
Secure from the other side using the threaded ring, illustrated in Figure A.
MWR75 Wired Remote Installation Instructions
MUTE

Operation / Operación / Fonctionnement
Power
Volume
Mode
Band
Pause
Clock/Info
Tuning
Wiring
Once the remote has been mounted, route the cable from the remote and connect the cable to the
radio. Note the connector polarity on the extension cable. The 18 foot extension cable may be
used to connect the remote to the radio. Up to two additional extension cables (MWREXT) may be
purchased and used to extend the reach of the remote up to 54 feet. Important: When connecting
the cables, be sure to route the extension cable away from sharp objects, corners, and places
where it might get pinched, as this could affect performance and cause damage to the unit. Up to
two more remote controls can be added with a "Y" cable adapter (MWRYCBLS).
POWER
BAND
MODE
MWR75
INFO
VOL
VOL
MUTE

MOUNTING TEMPLATE
2"
Learn more about marine electronics and navigation on our website.