manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Jiecang
  6. •
  7. Window Blind
  8. •
  9. Jiecang JCD25SLEU-SEH User manual

Jiecang JCD25SLEU-SEH User manual

Other Jiecang Window Blind manuals

Jiecang LEUB Series User manual

Jiecang

Jiecang LEUB Series User manual

Jiecang SR Series User manual

Jiecang

Jiecang SR Series User manual

Popular Window Blind manuals by other brands

Windhager PLUS 100x120 cm quick start guide

Windhager

Windhager PLUS 100x120 cm quick start guide

Rollos S-Nanorollo V2 Assembly and operating instruction

Rollos

Rollos S-Nanorollo V2 Assembly and operating instruction

IKEA KADRILJ manual

IKEA

IKEA KADRILJ manual

Teptron Move user manual

Teptron

Teptron Move user manual

Renson Outdoor Loggia Manual Installation

Renson

Renson Outdoor Loggia Manual Installation

rollease acmeda Easy Spring Air Assembly and installation manual

rollease acmeda

rollease acmeda Easy Spring Air Assembly and installation manual

Hallis Hudson Rolls Super glide instructions

Hallis Hudson

Hallis Hudson Rolls Super glide instructions

Jysk ROGEN manual

Jysk

Jysk ROGEN manual

SOMFY 1241752 instructions

SOMFY

SOMFY 1241752 instructions

MV LINE CLARA 015 Installing instructions

MV LINE

MV LINE CLARA 015 Installing instructions

Project Source CDLF2342W quick start guide

Project Source

Project Source CDLF2342W quick start guide

Current E-WAND Installation manual and user's guide

Current

Current E-WAND Installation manual and user's guide

weinor VertiTex ZipR Maintenance Instructions and Directions for use for the end user

weinor

weinor VertiTex ZipR Maintenance Instructions and Directions for use for the end user

Roto ZAR M R4/R7 Mounting instructions

Roto

Roto ZAR M R4/R7 Mounting instructions

Benthin P1614 quick start guide

Benthin

Benthin P1614 quick start guide

MDT KNX Smart 55 BE-JTA5504.01 Technical manual

MDT

MDT KNX Smart 55 BE-JTA5504.01 Technical manual

Victoria M SYSTEM VS 1 Original instructions

Victoria M

Victoria M SYSTEM VS 1 Original instructions

SOMFY Movelite WT Series instructions

SOMFY

SOMFY Movelite WT Series instructions

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.

H
3
Caution
5V/2A Type-C USB Charging
Up Stop Down
Prg Type-C USB charging port
Wand Motor
Prg
Motor Head Button(H)
1.This product is for indoor use only, do not use outdoor or in humid environments.
2.This motor has built-in rechargeable Li-ion battery pack with integrated charge
management. Max input voltage: 5V/2A.
3.Please charge it before using for the first time, make sure it is fully charged before first
use. During charging, the blue LED will flicker 3 times every 8 seconds.
After fully charged, the blue LED will be always on.
4.When the battery voltage is low, LED will flicker 8 times to give a low-voltage alarm when
motor starts.
5.The motor will jog in operation, please do not proceed to the next step until it complete.
6.During operation, the effective interval of the transmitter button operation is 10 seconds.
If there is no effective transmitter operation for more than 10 seconds, it will automatically
exit the current mode.
7. Please do not use motor when charging.
8.Upper&Lower limits cannot be set at the same position, limits saved even power off.
9.The motor runs constantly for at 6 mins max without any other operation.
Sleep Mode,
Wand Control Inactive
Reset
Hold H button or Prg for 6s,
LED flickers twice to show
the motor is in sleep mode
and wand control is inactive;
hold H button or Prg for 2s,
it will exit from sleep mode
and wand control is active
again
constant-touch
a.Direction Reverse
b.Upper&Lower Limits Setting
4
.Position Percent Setting
Short press 3 times
Adjust Lower limit
50% position mode
Note: Short press Stop button to exit this mode.
After selecting the percentage position,the motor will automatically run to
that position after 3 seconds of releasing the button.
10% increase
per press
Prg
10% reduction
per press
Prg
cOne-touch/Constant-touch Mode
One-touch
Constant-touch
d.Setting and Cancelling Favorite Position
e.Hot key to the Fav. Position
f.Adjusting Upper & Lower Limits
g.Adjusting Motor Speed
There are 3 speeds adjustable.
1.Hold H button or Prg for 2s
to activate motor
2.Charging