Jiecang SR Series User manual

AC Tubular Motor with
Mechanical Limits & RF Receiver
User Manual
01 Product Info
02 Caution!
03 Instructions
White line
R
R: Mechanical limit + built-in
RF receiver ( 230V/50Hz )
RL: Mechanical limit + built-in
RF receiver ( 110V/60Hz )
a.Pairing Motor with Controller
Note: Pairing can not be done under group channel or 0 channel.
b.Direction Reverse
Power Wire
Power on, add a new controller
1.The power supply is AC supply.
2.Please confirm the rated voltage and frequency according to the nameplate
when using it.
3.One motor cannot be connected to two switches or external receivers at
the same time.
4.Two motors cannot be connected in parallel to the same switch or external
receiver.
5.The motor can be paried with max 10 remote controllers.
6.The motor cannot be immersed in liquid for use.
7.Please do not use heavy objects or sharp objects to damage the motor.
8.Do not lift the motor by grabbing and pulling the power wire.

c.Upper&Lower Limits Setting
04 Troubleshooting
Stop
Note: When motor in one-touch mode, hold Up or Down for more than 2s, it will run in
constant-touch mode.
Constant-touch ------>One-touch
Same operation can toggle from one-touch to constant -touch mode.
Prg Jog x1 Jog x1 Stop Jog x1
OK
P
d.One-touch/Constant-touch Mode
Remove a single controller
h.Removing Controllers
Prg on
existing A
Stop on B
(to remove)
Jog x1 Prg on
existing A
Jog x1 Jog x1
P P
Remove all controllers:
Prg Down
All controllers removed
Jog x1 Prg Jog x1 Jog x1
P P
Controller B removed
Note: All the settings are saved even controllers removed(limits set are saved).
Controller A/B are already paired to motor.
remote contorller
remote contorller
Note: When motor is not working, do not turn the hole with hexdriver.
Inside limit switch of motor
doesn't open
1.Adjust the voltage to rated
data
The motr has exceeded termal
overheat protection (4 minutes)
Wait for the motor to cool
down for approximately 20
minutes
1.The crown and drive adapter
are not well adapterd to tube
2.The driving tube is too long,
cused the brackets are too
tightly
1.Change correct size crown
and drive adapter
2.If idler is active, make
driving tube shorter to
avoid the tight status